AI

## Overview of CTLL2012F-R39J
I can't confirm the manufacturer or exact datasheet for this part number, but the designation follows a common chip inductor convention, so you can decode most of its specifications from the code.
---
## Decoding the Part Number
| Segment | Meaning (typical interpretation) |
|---|---|
| **CTLL** | Series or product family code, which identifies the manufacturer and product line |
| **2012** | Package size: 2.0 mm × 1.2 mm (EIA 0805 / metric 2012) |
| **F** | Construction or series variant, often thin-film or a specific winding/termination type |
| **R39** | Inductance value: **0.39 µH** (the "R" stands for the decimal point) |
| **J** | Inductance tolerance: **±5%** |
---
## Key Electrical Characteristics
| Parameter | Typical Value / Notes |
|---|---|
| Inductance | 0.39 µH (390 nH) |
| Tolerance | ±5% |
| Package | 2012 (2.0 × 1.25 mm, low-profile chip) |
| Rated current (Irms) | Usually around 1 to 2 A for this size, depending on the series |
| Saturation current (Isat) | Typically somewhat higher than Irms; check the datasheet |
| DC resistance (DCR) | Typically tens of milliohms |
| Self-resonant frequency (SRF) | Typically tens of MHz |
| Q factor | Moderate, depending on frequency |
---
## Typical Applications
- DC-DC converter power stages (buck, boost) in portable devices
- Power filtering and noise suppression on supply rails
- RF matching and filter networks
- Point-of-load regulation in smartphones, wearables, and IoT devices
---
## Design Considerations
1. **Current rating:** Keep operating current below the saturation current to avoid inductance drop.
2. **Temperature rise:** Account for DCR losses (I²R) and board thermal conditions.
3. **Layout:** Place the inductor close to the switching IC and keep the switching loop short.
4. **Frequency:** Stay well below the SRF for predictable inductive behavior.
---
## Next Step
To get exact ratings (Irms, Isat, DCR, SRF, and dimensions), look up **"CTLL2012F-R39J datasheet"** on the manufacturer's website or on a distributor site such as Digi-Key, Mouser, or LCSC. If you share the datasheet or the manufacturer name, I can give you a more precise breakdown.
- ⤷What is the difference between Irms and Isat for an inductor?
- ⤷ How do I calculate the right inductor value for a buck converter?
- ⤷ What causes inductor saturation and how can I avoid it?