Description
The Si2035 is a programmable stepper drive/
indexer packaged in a rugged steel case . Integral
heat sink, mounting brackets, switch covers and
connectors are included with each Si2035. The
drive/indexer has been matched with nine
recommended NEMA 11, 14, 17 and 23 motors
and comes with all operating software necessary to
create a complete stepper motion solution.
The Si2035 includes Applied Motion Products' ,
Microsoft Windows based, Si™ software language
for quick set up and ease of use. The Si™ is ideal
for stand-alone operation. For more experienced
users, with software development expertise, the
Si2035 also comes with Applied' s Si Command
Language (SCL) programming instruction set. SCL
allows for control of the Si™ drive from a host PC
or PLC thus permitting the user to perform a
variety of motion, I/O tasks and system status
retrieval via the host.
Multiple axis applications are handled by our
SiNet™ Hub Programmer, which gives you the
ability to control up to 8 Si™ drives, either stepper
or servo on the same hub. Not only can you
coordinate up to eight motors, the hub also has
access to the inputs and outputs of all the drives,
providing your program with up to 64 inputs and
24 outputs. You can also use Applied' s MMI
which allows the machine operator to enter
specific motion commands. Factory set to operate
at 110-volt input; the Si2035 can be set by the user
to operate at 220-volt input by a simply switch
selection.
Pluggable screw terminal blocks are provided for
the I/O, motor and AC power inputs. Mating
connectors, programming cable with computer
interface connector as well as all operating
software are provided with each Si™ drive.
Features:
• Si™ , Si Command Language (SCL) or SiNet Hub programming
languages included with drive
• AC input 110V or 220V switch selectable, 50-60 Hz
• DC bus voltage 28 VDC full load, 35 VDC nominal
• Software selectable motor current from 0.2 - 2.0 amps/
phase
• Software selectable motor resolution from 2,000 to
50,800 steps per revolution
• Software selectable idle current reduction 0, 25%, 50%
or 100%
• Eight optically isolated programmable inputs 12 – 24
VDC. 2,200 ohms internal resistance. Can be configured
for sinking (NPN) or sourcing (PNP) signals.
• Three optically isolated programmable outputs 30V max
VDC, 100mA maximum
• One 0 - 5 VDC analog input ( supported by SCL only )
• RS-232 for PC/MMI communications
• Dual H-bridge, pulse width modulated amplifier switching
at 26 KHz