Installing and Adjusting the WLB92 Hanging Bracket Kit

To install the hanging bracket kit, assemble the bracket components as shown.

6

1

2

2a

2b

3

4

5

* Drop-in t-nut grooves

1) Hanging cable (2)

2) Gripper (2)

2a) Plunger

2b) Cross cable nut

3) Cross cable (2)

4) Bracket (2)

5) M6 screws (4)

6) Drop-in t-nuts (4)

When feeding the cable through the gripper, allow at least one inch of cable beyond the gripper. Do not feed any excess cable into

the light housing. To adjust the gripper position:

1. Lift all weight off the gripper.

2. Press the plunger to release the cable.

3. Slide the gripper to a new position.

4. Release the plunger.

5. Tighten the cross cable nut manually.

Loosen

to adjust

Press in to

adjust the

hanging cable

Drop-in t-nuts are automatically secured inside the grooves when they are tightened.

Hanging Bracket Kit

2

www.bannerengineering.com - Tel: + 1 888 373 6767

P/N 183866 Rev. C