ST72311J2 datasheet(17/94 Pages) STMICROELECTRONICS

17 / 94 page

17/94

ST72311

3.2 RESET

3.2.1 Introduction

There are four sources of Reset:

– RESET pin (external source)

– Power-On Reset (Internal source)

– WATCHDOG (Internal Source)

– Low Voltage Detection Reset (internal source)

The Reset Service Routine vector is located at ad-

dress FFFEh-FFFFh.

3.2.2 External Reset

The RESET pin is both an input and an open-drain

output with integrated pull-up resistor. When one

of the internal Reset sources is active, the Reset

pin is driven low to reset the whole application.

3.2.3 Reset Operation

The duration of the Reset condition, which is also

reflected on the output pin, is fixed at 4096 internal

CPU Clock cycles. A Reset signal originating from

an external source must have a duration of at least

1.5 internal CPU Clock cycles in order to be recog-

nised. At the end of the Power-On Reset cycle, the

MCU may be held in the Reset condition by an Ex-

ternal Reset signal. The RESET pin may thus be

used to ensure VDD has risen to a point where the

MCU can operate correctly before the user pro-

gram is run. Following a Power-On Reset event, or

after exiting Halt mode, a 4096 CPU Clock cycle

delay period is initiated in order to allow the oscil-

lator to stabilise and to ensure that recovery has

taken place from the Reset state.

During the Reset cycle, the device Reset pin acts

as an output that is pulsed low. In its high state, an

internal pull-up resistor is connected to the Reset

pin. This resistor can be pulled low by external cir-

cuitry to reset the device.

Figure 12. Reset Block Diagram

INTERNAL

RESET

WATCHDOG RESET

OSCILLATOR

SIGNAL

RESET

TO ST7

RESET

POWER-ON RESET

VDD

LOW VOLTAGE DETECTOR RESET

ST72311J2 Datasheet(PDF) 17 Page - STMicroelectronics

ST72311J2 Datasheet(HTML) 17 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94

Datasheet Download

Link URL