Eaton

Electronics Division

1000 Eaton Boulevard

Cleveland, OH 44122

United States

Eaton.com/electronics

© 2022 Eaton

All Rights Reserved

Printed in USA

Publication No. ELX1165 BU-ELX22024

March 2022

Technical Data ELX1165

Effective March 2022

EPM25-1V 15 W

15 Watt isolated DC-DC converter

Life Support Policy: Eaton does not authorize the use of any of its products for use in life support devices or systems without the express written

approval of an officer of the Company. Life support systems are devices which support or sustain life, and whose failure to perform, when properly used

in accordance with instructions for use provided in the labeling, can be reasonably expected to result in significant injury to the user.

Eaton reserves the right, without notice, to change design or construction of any products and to discontinue or limit distribution of any products. Eaton also

reserves the right to change or update, without notice, any technical information contained in this bulletin.

Eaton is a registered trademark.

All other trademarks are property

of their respective owners.

Follow us on social media to get the

latest product and support information.

General information

Storage and handling

The shelf life will be a minimum of 36 months, when stored at the

following conditions: < +40 °C, < 90% RH.

Wave solder profile

The wave solder profile is measured based on lead temperature. The

recommended PCB pre-heat temperature is +80 °C to +100 °C, and the

preheat rate of 1.5 to 2.5 °C/sec. The underside PCB temperature at the last

pre-heat zone should be approximately +150 °C. The internal temperature

of the solder parts should not exceed +210 °C. The duration of solder dwell

time should be between 3 to 5 seconds, and not to exceed 10 seconds at a

temperture of +260 °C maximum.