STM32H7B0IB datasheet(182/205 Pages) STMICROELECTRONICS

182 / 205 page

Notes

Dimensioning and tolerancing schemes conform to ASME Y14.5M-1994.

The top package body size may be smaller than the bottom package size by as much as 0.15 mm.

Datums A-B and D to be determined at datum plane H.

To be determined at seating datum plane C.

Dimensions D1and E1 do not include mold flash or protrusions. Allowable mold flash or protrusions is “0.25

mm” per side. D1 and E1 are Maximum plastic body size dimensions including mold mismatch.

Details of pin 1 identifier are optional but must be located within the zone indicated.

All dimensions are in millimeters.

No intrusion allowed inwards the leads.

Dimension “b” does not include dambar protrusion. Allowable dambar protrusion shall not cause the lead

width to exceed the maximum “b” dimension by more than 0.08 mm. Dambar cannot be located on the lower

radius or the foot. Minimum space between protrusion and an adjacent lead is 0.07 mm for 0.4 mm and 0.5

mm pitch packages.

10. Exact shape of each corner is optional.

11. These dimensions apply to the flat section of the lead between 0.10 mm and 0.25 mm from the lead tip.

12. A1 is defined as the distance from the seating plane to the lowest point on the package body.

13. “N” is the number of terminal positions for the specified body size.

14. Values in inches are converted from mm and rounded to 4 decimal digits.

15. Drawing is not to scale.

Figure 83. LQFP176 - Recommended footprint

133

132

1.2

0.3

0.5

1.2

21.8

26.7

176

Note:

Dimensions are expressed in millimeters.

7.4.1

Device marking for LQFP176

The following figure gives an example of topside marking versus pin 1 position identifier location.

The printed markings may differ depending on the supply chain.

Other optional marking or inset/upset marks, which depend on supply chain operations, are not indicated below.

STM32H7B0xB

LQFP176 package information

DS13196 - Rev 7

page 182/205

STM32H7B0IB Datasheet(PDF) 182 Page - STMicroelectronics