| Electronic Components Datasheet Search |
|
HVLED101 Datasheet(PDF) 25 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
HVLED101 Datasheet(HTML) 25 Page - STMicroelectronics |
|
25 / 36 page ![]() When input voltage surpasses the programmed value, the input overvoltage protection stops the switching activity and activates the discharge current IBLEED (where required). During iOVP, the internal THD optimizer drives the internal switched resistor always OFF (setting δc = 0 in Section 6.3.1 ) and the THD pin is set in high impedance. IBLEED current discharges the input capacitor to speed up the recover from surge occurrence. In case of steady input overvoltage, the VCC pin rises until the IBLEED generator automatically reduces the absorbed current. At this occurrence, the HVSU unit provides the whole current for HVLED101 and the input capacitor is discharged by a current that is almost equal to ICC plus the internal consumption of the HVSU unit. When HVSU voltage is lower than protection level, the HVSU charges VCC to reach VCC-ON (if required) and active mode is entered. Figure 16. iOVP waveforms VCC ViOVP VHVSU Low consumption (fault) Active Mode Temporary Overvoltage (e.g. surge) Active Mode VCC-ON IHVSU IVcc IBLEED IHV-ON ICC-L - ICHG-L ICC ~19V ~ ICC VCC-OFF 6.8.3 Brownout protection (BO) In order to avoid operation at insufficient input voltage, the IC moves to low consumption mode if the input voltage is lower than the programmed threshold (Table 9) for at least TBO (500 ms min.). During masking time (TBO-LEB), activated after brownout triggering time, the HVSU comparator is ignored to prevent false restart due to EMI filter resonance oscillations, while IBLEED is turned on to discharge any residual oscillation due to EMI filter operating condition at turn-off instant. After the end of TBO_LEB, the input voltage is checked to be higher than the threshold only during the charging period of VCC: a small time (TDBNC) is applied after HVSU activation to prevent false reading. To be noted that the value of the resistance that is in series with the HVSU pin, multiplied by ICHG-H, sets the hysteresis for brownout threshold voltage. HVLED101 Protections DS14143 - Rev 2 page 25/36 |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |