PTVA084007NF

7

Rev. 04.2, 2022-02-13

© 2022 Wolfspeed, Inc. All rights reserved. Wolfspeed® and the Wolfstreak logo are registered trademarks and the Wolfspeed logo is a trademark of Wolfspeed, Inc.

The information in this document is subject to change without notice.

4600 Silicon Drive | Durham, NC 27703 | Tel: +1.919.313.5300

10°

PG-HBSOF-4-1_part1_03_07-13-2016

R0.

5

22.7 ± 0.15

6

0.5

16.75

20

1

1.52

2 X 1.19

25.4

0.63

16.75

2 X 1.61

1

1.52

1.57 ± 0.15

1.17

Y

3

0.1 MAX.

G

D

V

V

25.4

Diagram Notes–unless otherwise specified:

1. Mold/dam bar/metal protusion of 0.30 mm max per side not included.

2. Metal protrusion are connected to source and shall not exceed 0.10 mm max.

3. Fillets and radii: all radii are 0.3 mm max.

4. Interpret dimensions and tolerances per ISO 8015.

5. Dimensions are mm.

6. Does not include mold/dam bar/metal protusion.

7. Exposed metal surface pre-plated, may not be covered by mold compound.

8. All tolerances ± 0.1 mm unless specified otherwise.

9. All metal surfaces pre-plated, except area of cut.

10. Lead thickness: 0.25 mm.

11. Gold plating thickness: 0.25 micron max.

12. Pins: D – drain; G – gate; S – source; V – V

DD.

PG-HBSOF-4-2_part1_01_11-23-2016

Diagram Notes – unless otherwise specified:

1. Modem/dam bar/metal protrusion of 0.30 mm max per side not included.

2. Metal protrusion are connected to source and shall not exceed 0.10 mm max.

3. Fillets and radii: all radii are 0.3 mm max.

4. Interpret dimensions and tolerances per ISO 8015.

5. Dimensions are mm.

6. Dose not include mold/dam bar/metal protrusion.

7. Exposed metal surface is tin-plated, may not be covered by mold compound.

8. All toleranceds ± 0.1 mm unless specified otherwise.

9. All metal surfaces are tin-plated, except area of cut.

10. Lead thickness: 0.25 mm.

11. Pins: D = drain; G = gate; S – source; V = drain video decoupling (use only

for decoupling), not for DC bias.

Package Outline Specifications – Package PG-HBSOF-4-2