AM29BL162C datasheet(18/52 Pages) AMD

18 / 52 page

Am29BL162C

22142F9 January 22, 2007

D A TA

SH EET

Temporary Sector Unprotect

This feature allows temporary unprotection of previ-

ously protected sectors to change data in-system. The

Sector Unprotect mode is activated by setting the RE-

SET# pin to VID. During this mode, formerly protected

sectors can be programmed or erased by selecting the

sector addresses. Once VID is removed from the RE-

SET# pin, all the previously protected sectors are

protected again. Figure 2 shows the algorithm, and

Figure 23 shows the timing diagrams, for this feature.

HARDWARE DATA PROTECTION

The command sequence requirement of unlock cycles

for programming or erasing provides data protection

against inadvertent writes (refer to Table 8 for com-

mand definitions). In addition, the following hardware

data protection measures prevent accidental erasure

or programming, which might otherwise be caused by

spurious system level signals during VCC power-up and

power-down transitions, or from system noise.

Low VCC Write Inhibit

When VCC is less than VLKO, the device does not ac-

cept any write cycles. This protects data during VCC

power-up and power-down. The command register and

all internal program/erase circuits are disabled, and the

device resets. Subsequent writes are ignored until VCC

is greater than VLKO. The system must provide the

proper signals to the control pins to prevent uninten-

tional writes when VCC is greater than VLKO.

Write Pulse “Glitch” Protection

Noise pulses of less than 5 ns (typical) on OE#, CE# or

WE# do not initiate a write cycle.

Logical Inhibit

Write cycles are inhibited by holding any one of OE# =

VIL, CE# = VIH or WE# = VIH. To initiate a write cycle,

CE# and WE# must be a logical zero while OE# is a

logical one.

Power-Up Write Inhibit

If WE# = CE# = VIL and OE# = VIH during power up, the

device does not accept commands on the rising edge

of WE#. The internal state machine is automatically

reset to reading array data on power-up.

START

Perform Erase or

Program Operations

RESET# = VIH

Temporary Sector

Unprotect Completed

(Note 2)

RESET# = VID

(Note 1)

Notes:

1. All protected sectors unprotected.

2. All previously protected sectors are protected once

again.

Figure 2.

Temporary Sector Unprotect Operation

AM29BL162C Datasheet(PDF) 18 Page - Advanced Micro Devices

AM29BL162C Datasheet(HTML) 18 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Datasheet Download

Link URL