MMIC Medium Level Mixer

800 - 1000 MHz

MAMXSS0011

M/A-COM Inc. and its affiliates reserve the right to make changes to the

product(s) or information contained herein without notice. M/A-COM makes

no warranty, representation or guarantee regarding the suitability of its

products for any particular purpose, nor does M/A-COM assume any liability

whatsoever arising out of the use or application of any product(s) or

information.

• North America Tel: 800.366.2266 / Fax: 978.366.2266

• Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300

• Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298

Visit www.macom.com for additional data sheets and product information.

V2

2

RoHS

Compliant

Electrical Specifications:

Parameter

Test Conditions

Units

Min

Typ

Max

Conversion Loss

—

dB

—

7.5

9.5

Isolation

LO to RF

LO to IF

RF to IF

dB

dB

dB

—

—

—

38

22

12

—

—

—

VSWR

LO Port

RF Port

IF Port

Ratio

Ratio

Ratio

—

—

—

2.5:1

2.0:1

2.0:1

—

—

—

Input 1 dB Compression

RF Freq. = 900 MHz, LO = +13 dBm

dBm

—

+21

—

Two tones at –10 dBm each,

Tone spacing 100 kHz, IF = 60 MHz

dBc

45

60

—

4x

8.9

-1.1

40.1

39.9

70.1

61.6

69.9

63.9

73.4

64.4

3x

2.2

-7.7

34.2

34.1

59.8

63.8

67.3

64.5

73

63

2x

2.9

-7.1

23.7

23.8

72.8

64.7

72.9

63.3

71.9

61.9

1x

-2.2

-12.2

0

0

61.4

63.3

71.3

61.8

71.1

61.9

0x

X

X

4.7

4.8

65.1

61.3

71.5

61.9

72.1

62.3

0x

1x

2x

3x

4x

Harmonic of RF

Spurious Table

The spurious table shows the spurious signals resulting from the

mixing of the RF and LO input signals, assuming down

conversion. Mixing products are indicated by the number of dB

below the conversion loss. The lower frequency mixing term is

shown for two different RF input levels. The top number is for an

RF input power of -5 dBm, the lower number is for -15 dBm.

RF Frequency = 900 MHz

LO Frequency = 840 MHz

Parameter

Absolute Maximum

+22 dBm

+23 dBm

Operating Temperature

-40°C to +85°C

Storage Temperature

-65°C to +150°C

2. Exceeding any one or combination of these limits may cause

permanent damage to this device.

3. M/A-COM does not recommend sustained operation near

these survivability limits.

4. Total combined power for RF and LO ports should not

exceed +23 dBm.

Handling Procedures

Please observe the following precautions to avoid

damage:

Static Sensitivity

Gallium Arsenide Integrated Circuits are sensitive

to electrostatic discharge (ESD) and can be

damaged by static electricity. Proper ESD control

techniques should be used when handling these

devices.