TS3USB30 datasheet(5/12 Pages) TI

5 / 12 page

www.ti.com

Switching Characteristics

TS3USB30

HIGH-SPEED USB 2.0 (480-Mbps) 1:2 MULTIPLEXER/DEMULTIPLEXER SWITCH

WITH SINGLE ENABLE

SCDS237 – JUNE 2007

over operating range, T

A = –40°C to 85°C, VCC = 3.3 V ± 10%, GND = 0 V

PARAMETER

TEST CONDITIONS

MIN

TYP(1)

MAX

UNIT

RL = 50 Ω, CL = 5 pF,

tpd

Propagation delay(2)(3)

0.25

See Figure 11

RL = 50 Ω, CL = 5 pF,

tON

Line enable time, SEL to D, nD

See Figure 7

RL = 50 Ω, CL = 5 pF,

tOFF

Line disable time, SEL to D, nD

See Figure 7

RL = 50 Ω, CL = 5 pF,

tON

Line enable time, OE to D, nD

See Figure 7

RL = 50 Ω, CL = 5 pF,

tOFF

Line disable time, OE to D, nD

See Figure 7

Output skew between center port to any other

RL = 50 Ω, CL = 5 pF,

tSK(O)

port(2)

See Figure 12

Skew between opposite transitions of the same

RL = 50 Ω, CL = 5 pF,

tSK(P)

output

See Figure 12

(tPHL – tPLH)(2)

RL = 50 Ω, CL = 5 pF,

Total Jitter(2)

tR = tF = 500 ps at 480

Mbps (PRBS = 215 -1)

(1)

For max or min conditions, use the appropriate value specified under "electrical characteristics" for the applicable device type.

(2)

Specified by design

(3)

The bus switch contributes no propagational delay other than the RC delay of the on resistance of the switch and the load capacitance.

The time constant for the switch alone is of the order of 0.25 ns for 10-pF load. Since this time constant is much smaller than the rise/fall

times of typical driving signals, it adds very little propagational delay to the system. Propagational delay of the bus switch, when used in

a system, is determined by the driving circuit on the driving side of the switch and its interactions with the load on the driven side.

Submit Documentation Feedback

TS3USB30 Datasheet(PDF) 5 Page - Texas Instruments

TS3USB30 Datasheet(HTML) 5 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

Datasheet Download

Link URL