TMS320VC33 datasheet(41/59 Pages) TI2

41 / 59 page

TMS320VC33

DIGITAL SIGNAL PROCESSOR

SPRS087E -- FEBRUARY 1999 -- REVISED JANUARY 2004

POST OFFICE BOX 1443

• HOUSTON, TEXAS 77251--1443

reset timing (continued)

EXTCLK

RESET

(see Notes A and C)

IACK

D[31:0]

PAGEx, A[23:0]

STRB

Asynchronous

Reset Signals

(see Note B)

R/W

Ten H1 Clock Cycles

tsu(RESET-EXTCLKL)

td(EXTCLKH-H1H)

td(EXTCLKH-H1L)

td(EXTCLKH-H3L)

tsu(RESETH-H1L)

tdis(H1H-DZ)

td(EXTCLKH-H3H)

td(H3H-CONTROLH)

tdis(H3H-AZ)

td(H1H-RWH)

td(H1H-IACKH)

tdis(RESETL-ASYNCH)

NOTES: A. Clock circuit is configured in ’C31-compatible divide-by-2 mode. If configured for x1 mode, EXTCLK directly drives H3.

B. Asynchronous reset signals include XF0/1, CLKX0, DX0, FSX0, CLKR0, DR0, FSR0, and TCLK0/1.

C. RESET is a synchronous input that can be asserted at any point during a clock cycle. If the specified timings are met, the exact

sequence shown occurs; otherwise, an additional delay of one clock cycle is possible.

D. In microprocessor mode, the reset vector is fetched twice, with seven software wait states each time. In microcomputer mode, the

reset vector is fetched twice, with no software wait states.

E. The address and PAGE3-PAGE0 outputs are placed in a high-impedance state during reset requiring a nominal 10--22 kΩ pullup.

If not, undesirable spurious reads can occur when these outputs are not driven.

Figure 28. RESET Timing

TMS320VC33 Datasheet(PDF) 41 Page - Texas Instruments