Data Sheet

ADRF5703

THEORY OF OPERATION

analog.com

Rev. 0 | 17 of 19

PARALLEL MODE INTERFACE

The ADRF5703 has seven digital control inputs, D0 (LSB) to D6

(MSB), to select the desired attenuation state in parallel mode, as

shown in Table 8.

There are two modes of parallel operation: direct parallel and

latched parallel.

Direct Parallel Mode

To enable direct parallel mode, keep the LE pin high. To change the

attenuation state, use the control voltage inputs (D0 to D6) directly.

Direct parallel mode is for manual control of the attenuator.

Latched Parallel Mode

To enable latched parallel mode, the LE pin must be kept low when

changing the control voltage inputs (D0 to D6) to set the attenuation

state. When the desired state is set, toggle LE high to transfer

the 7-bit data to the bypass switches of the attenuator array, and

then toggle LE low to latch the change into the device until the

next desired attenuation change (see Figure 37 and Table 3 for

additional information).

Figure 37. Latched Parallel Mode Timing Diagram