STR710-EVAL datasheet(26/27 Pages) STMICROELECTRONICS

26 / 27 page

5 Revision history

STR710-EVAL

25/27

Revision history

Date

Revision

Changes

26-September-2005

Initial external release.

4-October-2005

Amended

Section 2.1 on page 6 to list the JTAG connector CN9.

Amended

Section 2.8 on page 6 to improve the USB interface

description.

Amended

Section 2.9 on page 7 to improve the CAN interface

description.

Updated

Table 4: Option jumpers on page 10 to show J5 is not fitted.

Amended the wording for SW1 in

Table 5 on page 10.

Amended the first table entry in

Table 11 on page 14.

Updated

Chapter 4: Schematics:

Figure 11 on page 15:

C80 is now marked as “Do not fit”, IC20 reset circuit has a threshold

voltage of 3.07 V not 2.63 V.

Figure 12 on page 16 J5 marked as “Do not fit”.

Figure 15 on page 19 IC2 shown with correct connectivity. Note that

on the PCB, IC2 is connected with In/Out swapped.

Figure 19 on page 23, R92 is now removed because it was in

parallel with R83.

Updated

Section 2.9: CAN interface on page 7 to include caution.

Updated

Chapter 4: Schematics to include the latest revision of

schematics.

Removed list of third party support vendors from description.

STR710-EVAL Datasheet(PDF) 26 Page - STMicroelectronics