8

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

CHARGING USING THE MAINS ADAPTOR

1. Set the On/Off switch to the Off

position and the Voltage Selection

switch to the 12V position.

2. Plug the cable into the socket at

the rear of the unit, then plug the

adaptor into the mains supply

and switch on.

• The red CHARGING light on the

jumpstart will come on to

indicate charging is in progress.

3. It is best to charge the jumpstart until the green CHARGED light comes on.

• To ensure maximum battery life, it is desirable to charge the unit after

each occasion of use and recommended to recharge after every

30 days.

NOTE: Pressing the ‘TEST’ button with the charger disconnected will cause

the needle on the battery condition gauge shown above, to

register the state of charge of the battery.

Turn the unit on and a beep will be heard, indicating that there is power to the

booster clamps.

CHARGING USING THE 12V ADAPTOR

1. Plug the jack plug into the charging socket at the rear of the unit, then into

the cigarette lighter socket on the vehicle and start the engine. The red

LED on the jumpstart to indicate that charging is in progress.

2. Continue to charge until the “Internal Battery Status” gauge registers ‘OK’

when the ‘TEST’ button is pressed, WITH THE CHARGING CURRENT

DISCONNECTED. i.e. disconnect the cigarette lighter adapter from the

socket on the vehicle before pressing the Test Button.

NOTE: We recommend that you use this system only when necessary, as

prolonged use will reduce the life expectancy of the battery, due

to the fact that this method can only charge the battery to

approx. 50% of its capacity.

NOTE: For maximum battery life, we strongly recommend that you

maintain the battery in a fully charged state at all times.

NOTE: If charging does not take place, check the green LED on the

adapter. Ensure all connections are clean and free of grease etc.