TSM101AI datasheet(6/15 Pages) STMICROELECTRONICS

6 / 15 page

The optocoupler current increases and tends to

reduce the output voltage by the way of the PWM

controller.

By enabling the TSM101 current source (pin 2) it is

possible to offset the current sensing by a voltage

equal to :

• Voff # R4 * Io with Io = 1.4mA

This offset lowers the output charge current and

this function can be used to charge two types of

batteries having different capacities. The current

source is enabled by connecting pin 2 to ground

3 - CALCULATION OF THE ELEMENTS

The charge current is regulated at 700mA (if the

charge control input is left open) or 200mA (if the

charge control input is put to ground ), allowing the

charge of two different types of batteries.

3.1 - Voltage limitation

The end-of- charge voltage is limited at 1.45V/cell,

this is the recommended voltage for an ambient

temperature at 25

oC.

A diode is generally inserted at the output of the

charger to avoid the discharge of the battery if the

charger is not powered. This diode is sometimes

directly integrated in the battery pack. The influ-

ence of this diode on the charge is negligible if the

voltage drop (0.7V) is taken into account during the

design of the charger.

The voltage at the output of the charger is :

• Vout =

+R7

xVr

and regarding R6 and R7 :

• R6 =(

Vref

Vout − Vref

) xR7

P1, which is a part of R6 and R7 is not considered

in this equation.

The following values are used on the application

board :

• R7 = 12kΩ

• R6 = 1kΩ

• P1 = 220Ω, adjust for Voutput = 15.2V with the

battery replaced by a 1k

Ω resistor

• R10 = short circuit

• C3 = 100nF

3.2 - Current regulation

R5 is the sense resistor used for current measure-

ment.

Figure 2 : SMPS Using a TL431 as Voltage Controller

TSM101/A

6/15

TSM101AI Datasheet(PDF) 6 Page - STMicroelectronics

TSM101AI Datasheet(HTML) 6 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Datasheet Download

Link URL