MPC89x53AF datasheet(26/38 Pages) MEGAWIN

26 / 38 page

In other words, not all data reception will respond to RI, while specific data does.

By setting the SADDR and the SADEN, the user can filter out those data byte that doesn’t like

to care. This feature brings great help to reduce software overhead.

The above feature adapts to the serial port when operated in Mode1, Mode2, and Mode3.

Dealing with Mode 0, the user can ignore it.

Frame Error Detection

A missing bit in stop bit will set the FE bit in the SCON register. The FE bit shares the SCON

bit 7 with SM0 and its actual function for SCON.7 is determined by SMOD0 (PCON.6). If

SMOD0 is set, SCON.7 functions as FE, otherwise functions as SM0. When used as FE bit, it

can only be cleared by software.

Reset

The RESET pin is used to reset this device. It is connected into the device to a Schmitt Trigger

buffer to get excellent noise immunity.

Any positive pulse from RESET pin must be kept at least two-machine cycle, or the device

cannot be reset.

Power Saving Mode and POF

There are two power saving modes, which are selectable to drive the MPC89x53A enter

power-saving mode.

IDLE mode

The user can set the bit PCON.0 to drive this chip entering IDLE mode.

In the IDLE mode, the internal clock is gated off to the CPU, but not to the interrupt, timer and

serial port functions.

There are two ways to terminate the idle. Activation of any enabled interrupt will cause

PCON.0 to be cleared by hardware to terminating the idle mode. The interrupt will be serviced

and following RETI, the next instruction to be executed will be performed right after the

instruction that causes the device entering to idle mode. Another way to wake-up from idle is

to pull RESET pin high to generate internal hardware reset.

MPC89x53A Data Sheet

MEGAWIN

MPC89x53AF Datasheet(PDF) 26 Page - Megawin Technology Co., Ltd