ATmega16 datasheet(223/357 Pages) ATMEL

223 / 357 page

223

2466S–AVR–05/09

ATmega16(L)

The IEEE std. 1149.1 also specifies an optional TAP signal; TRST – Test ReSeT – which is not

provided.

When the JTAGEN fuse is unprogrammed, these four TAP pins are normal port pins and the

TAP controller is in reset. When programmed and the JTD bit in MCUCSR is cleared, the TAP

input signals are internally pulled high and the JTAG is enabled for Boundary-scan and program-

ming. In this case, the TAP output pin (TDO) is left floating in states where the JTAG TAP

controller is not shifting data, and must therefore be connected to a pull-up resistor or other

hardware having pull-ups (for instance the TDI-input of the next device in the scan chain). The

device is shipped with this fuse programmed.

For the On-chip Debug system, in addition to the JTAG interface pins, the RESET pin is moni-

tored by the debugger to be able to detect external reset sources. The debugger can also pull

the RESET pin low to reset the whole system, assuming only open collectors on the reset line

are used in the application.

Figure 112. Block Diagram

TAP

CONTROLLER

TDI

TDO

TCK

TMS

FLASH

MEMORY

AVR CPU

DIGITAL

PERIPHERAL

UNITS

JTAG / AVR CORE

COMMUNICATION

INTERFACE

BREAKPOINT

UNIT

FLOW CONTROL

UNIT

OCD STATUS

AND CONTROL

INTERNAL

SCAN

CHAIN

INSTRUCTION

BYPASS

JTAG PROGRAMMING

INTERFACE

Instruction

Address

Data

BREAKPOINT

SCAN CHAIN

ADDRESS

DECODER

I/O PORT 0

I/O PORT n

BOUNDARY SCAN CHAIN

DEVICE BOUNDARY

ATmega16 Datasheet(PDF) 223 Page - ATMEL Corporation

ATmega16 Datasheet(HTML) 223 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL