ST10F276Z5 datasheet(70/239 Pages) STMICROELECTRONICS

70 / 239 page

Bootstrap loader

ST10F276Z5

70/239

5.7

Selective boot mode

The selective boot is a subcase of the Alternate Boot mode. When none of the signatures

are correct, instead of executing the standard bootstrap loader (triggered by P0L.4 low at

reset), an additional check is made.

Address 00’1FFCh is read again with the following behavior:

●

If value is 0000h or FFFFh, a jump is performed to the standard bootstrap loader.

●

Otherwise:

–

High byte is disregarded.

–

Low byte bits select which communication channel is enabled.

Therefore a value:

●

0xXX03 configures the Selective Bootstrap Loader to poll for RxD0 and CAN1_RxD.

●

0xXX01 configures the Selective Bootstrap Loader to poll only RxD0 (no boot via CAN).

●

0xXX02 configures the Selective Bootstrap Loader to poll only CAN1_RxD (no boot via

UART).

●

Other values allow the ST10F276Z5 to execute an endless loop into the Test-Flash.

Table 38.

Selective boot

Bit

Function

UART selection

‘0’: UART is not watched for a Start condition.

‘1’: UART is watched for a Start condition.

CAN1 selection

‘0’: CAN1 is not watched for a Start condition.

‘1’: CAN1 is watched for a Start condition.

2..7

Reserved

For upward compatibility, must be programmed to ‘0’

ST10F276Z5 Datasheet(PDF) 70 Page - STMicroelectronics