SPX5205M5 datasheet(2/9 Pages) SIPEX

2 / 9 page

Rev. 10/24/00

SPX5205

ABSOLUTE MAXIMUM RATINGS

RECOMMENDED OPERATING CONDITIONS

Thermal Shutdown .................................... Internally Limited

Input Voltage................................................. +2.5V to +16V

Lead Temp. (Soldering, 5 Seconds) ............................ 260

°C

Operating Junction Temperature Range ..... -40

°C to +125°C

Operating Junction Temperature Range ..... -40

°C to +125°C

Enable Input Voltage............................................. 0V to VIN

Input Supply Voltage........................................-20V to +20V

SOT-23-5 (

θJA) ..................................................... See Note 1

Enable Input Voltage........................................-20V to +20V

ELECTRICAL CHARACTERISTICS

TJ = 25

°C, VIN = VOUT + 1V, IL = 100µA, CL = 1µF, and VENABLE > 2.4V. Unless otherwise specified boldface applies over the

junction temperature range

Parameter

Test Conditions

Typ

Min

Max

Units

Output Voltage Tolerance (VOUT)

IL = 100

µA

IL = 500

µA

-1

-2

%VNOM

Output Voltage Temperature Coefficient

ppm/

°C

Line Regulation

VIN = VOUT + 1V to 16V

0.03

0.1

0.2

%/V

Load Regulation

IL = 0.1mA to 150mA

0.1

0.2

0.5

IL = 100

µA

IL = 50 mA

140

190

230

IL = 100 mA

180

250

300

Dropout Voltage (See Note 2)

(VIN - VO)

IL = 150 mA

210

275

350

Quiescent Current (IGND)

VENABLE < 0.6V

VENABLE < 0.25V

< 1

µA

IL = 100

µA

125

150

IL = 50 mA

350

600

800

IL = 100 mA

750

1000

1500

Ground Pin Current

(IGND)

IL = 150 mA

1300

1900

2500

µA

Ripple Rejection (PSRR)

Current Limit (ILIMIT)

VOUT = 0V

360

500

Output Noise (eNO)

IL = 50mA, CL = 1

µF

10Hz – 100Khz.)

390

µVRMS

Input Voltage Level

Logic Low (VIL)

OFF

0.6

Input Voltage Level

Logic High (VIL)

2.0

ENABLE Input Current

VIL < 0.6V

VIH > 2.0V

0.01

µA

Note 1: The maximum allowable power dissipation is a function of maximum operating junction temperature, TJ (max), the junction to ambient thermal resistance, and

the ambient,

θJA, and the ambient temperature TA. The maximum allowable power dissipation at any ambient temperature is given:

PD (max) = (TJ (max) - TA)/

θJA, exceeding the maximum allowable power limit will result in excessive die temperature; thus, the regulator will go into thermal shutdown.

The

θJA of the SPX5205 is 220oC/W mounted on a PC board.

Note 2: Not apply to 1.8V version.

SPX5205M5 Datasheet(PDF) 2 Page - Sipex Corporation

SPX5205M5 Datasheet(HTML) 2 Page - Sipex Corporation

Html Pages

1 2 3 4 5 6 7 8 9

Datasheet Download

Link URL