SPC564L54L5 datasheet(73/160 Pages) STMICROELECTRONICS

Part #	SPC564L54L5

Description	32-bit Power Architecture® microcontroller for automotive SIL3/ASILD chassis and safety applications

PDF	160 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

73 / 160 page

SPC56XL60/54

Package pinouts and signal descriptions

Doc ID 15457 Rev 8

73/160

Note:

None of system pins (except RESET) provides an open drain output.

2.4

Pin muxing

Table 8 defines the pin list and muxing for this device.

Each entry of Table 8 shows all the possible configurations for each pin, via the alternate

functions. The default function assigned to each pin after reset is indicated by ALT0.

Note:

Pins labeled “NC” are to be left unconnected. Any connection to an external circuit or

voltage may cause unpredictable device behavior or damage.

Pins labeled “Reserved” are to be tied to ground. Not doing so may cause unpredictable

device behavior.

This pad contains a weak pull-up.

EXTAL is an "Output" in "crystal" mode, and is an "Input" in "ext clock" mode.

In XOSC Bypass Mode, the analog portion of crystal oscillator (amplifier) is disabled. An external clock can be applied at

EXTAL as an input. In XOSC Normal Mode, EXTAL is an output

This pad contains a weak pull-down.

RESET output shall be considered valid only after the 3.3V supply reaches its stable value.

SPC564L54L5 Datasheet(PDF) 73 Page - STMicroelectronics