8

Sheet No.: D2-A09201EN

PC4D10SNIP0F Series

■ Design Considerations

● Recommended operating conditions

Parameter

Symbol

MIN.

TYP.

MAX.

Unit

Low level input current

0

−

250

μA

High level input current

8

−

15

mA

Supply voltage

4.5

−

5.5

V

Fan out (TTL load)

N

−−

5

−

Output pull-up resitor

330

−

4 000

Ω

Operating temperature

−40

−

+85

˚C

● Notes about static electricity

Transistor of detector side in bipolar configuration may be damaged by static electricity due to its minute de-

sign.

When handling these devices, general countermeasure against static electricity should be taken to avoid

breakdown of devices or degradation of characteristics.

● Design guide

In order to stabilize power supply line, we should certainly recommend to connect a by-pass capacitor of

In case that some sudden big noise caused by voltage variation is provided between primary and secondary

terminals of photocoupler some current caused by it is floating capacitance may be generated and result in

false operation since current may go through LED or current may change.

If the photocoupler may be used under the circumstances where noise will be generated we recommend to

use the bypass capacitors at the both ends of LED.

The detector which is used in this device, has parasitic diode between each pins and GND.

There are cases that miss operation or destruction possibly may be occurred if electric potential of any pin

becomes below GND level even for instant.

Therefore it shall be recommended to design the circuit that electric potential of any pin does not become

below GND level.

This product is not designed against irradiation and incorporates non-coherent LED.

● Degradation

In general, the emission of the LED used in photocouplers will degrade over time.

In the case of long term operation, please take the general LED degradation (50% degradation over 5 years)

into the design consideration.

● Recommended foot print (reference)

1.9

7.49

(Unit : mm)