33

AT45DB321D [DATASHEET]

3597T–DFLASH–11/2013

19.1

Utilizing the RapidS Function

To take advantage of the RapidS function's ability to operate at higher clock frequencies, a full clock cycle must be used to

transmit data back and forth across the serial bus. The DataFlash device is designed to always clock its data out on the falling

edge of the SCK signal and clock data in on the rising edge of SCK.

For full clock cycle operation to be achieved when the DataFlash device is clocking data out on the falling edge of SCK, the host

controller should wait until the next falling edge of SCK to latch the data in. Similarly, the host controller should clock its data out

on the rising edge of SCK in order to give the DataFlash device a full clock cycle to latch the incoming data in on the next rising

edge of SCK.

Figure 19-1. RapidS Mode

Figure 19-2. Reset Timing

Note:

The CS signal should be in the high state before the RESET signal is deasserted.

SCK

MOSI

MISO

1

234567

81

234567

8

MOSI = Master Out, Slave In

MISO = Master In, Slave Out

The Master is the host controller and the Slave is the DataFlash

The Master always clocks data out on the rising edge of SCK and always clocks data in on the falling edge of SCK.

The Slave always clocks data out on the falling edge of SCK and always clocks data in on the rising edge of SCK.

A.

Master clocks out first bit of BYTE-MOSI on the rising edge of SCK

B.

Slave clocks in first bit of BYTE-MOSI on the next rising edge of SCK

C.

Master clocks out second bit of BYTE-MOSI on the same rising edge of SCK

D.

Last bit of BYTE-MOSI is clocked out from the Master

E.

Last bit of BYTE-MOSI is clocked into the slave

F.

Slave clocks out first bit of BYTE-SO

G.

Master clocks in first bit of BYTE-SO

H.

Slave clocks out second bit of BYTE-SO

I.

Master clocks in last bit of BYTE-SO

A

B

C

D

E

F

G

1

H

BYTE-MOSI

MSB

LSB

BYTE-SO

MSB

LSB

Slave

CS

I

CS

SCK

RESET

SO (OUTPUT)

High impedance

High impedance

SI (INPUT)

tRST

tREC

tCSS