RF Micro Devices Inc.

7628 Thorndike Road, Greensboro, NC 27409-9421

DS140820

For sales or technical support, contact RFMD at +1.336.678.5570 or customerservice@rfmd.com.

The information in this publication is believed to be accurate. However, no responsibility is assumed by RF Micro Devices, Inc. ("RFMD") for its use, nor for any infringement of patents or other rights of

third parties resulting from its use. No license is granted by implication or otherwise under any patent or patent rights of RFMD. RFMD reserves the right to change component circuitry, recommended

application circuitry and specifications at any time without prior notice.

2 of 7

RFAM3790

Absolute Maximum Ratings

Parameter

Rating

Unit

DC Supply Over-Voltage (5 minutes)

14

V

Storage Temperature

-40 to +100

°C

Operating Mounting Base Temperature

-30 to +100

°C

Moisture Sensitivity Level IPC/JEDEC J-STD-20

MSL 3 @260

°C

Caution! ESD sensitive device.

RoHS status based on EU Directive

2011/65/EU

Exceeding any one or a combination of the Absolute

Maximum Rating conditions may cause permanent

damage to the device. Extended application of Absolute

Maximum Rating conditions to the device may reduce

device reliability. Specified typical performance or

functional operation of the device under Absolute

Maximum Rating conditions is not implied.

Nominal Operating Parameters

Parameter

Specification

Unit

Condition

Min

Typ

Max

General Performance

V+= 12V; TMB=30°C; ZS=ZL=75

Ω; Att=0dB

Power Gain

27.0

dB

f=45MHz

27.5

28.5

29.5

dB

f=1218MHz

Slope

[1]

0.5

1.5

2.5

dB

f=45MHz to 1218MHz

Flatness of Frequency Response

0.5

1.0

dB

f=45MHz to 1218MHz (Peak to Valley)

Input Return Loss

18

dB

f=45MHz to 1003MHz

16

dB

f=1003MHz to 1218MHz

Output Return Loss

15

dB

f=45MHz to 1003MHz

15

dB

f=1003MHz to 1218MHz

Noise Figure

4.0

5.0

dB

f=50MHz to 1218MHz

Total Current Consumption (DC)

410

450

mA

Attenuator

V+= 12V; TMB=30°C; ZS=ZL=75

Ω;

Attenuator Range

0 to 20

dB

Attenuator Voltage 0V to 12V

Power Enable/Disable

Amp

enabled

Logic high (3.3V) applied to power enable pin

[2]

Amp

disabled

Logic low (0V) applied to power enable pin

[3]