PN79082 datasheet(2/4 Pages) MALLORY

2 / 4 page

INSTALLATION INSTRUCTIONS

MSD • W W W. M S D PE R F OR M A NC E . C OM • ( 91 5 ) 8 57 - 5 20 0 • F AX ( 91 5 ) 8 57 - 33 4 4

5. Loosen the band clamp and position the

generator so the rotor tip is just leading into

the number one cylinder mark (from step 4)

indicating the number one cylinder (Figure

3). This will put the timing approximately 2°-3°

within TDC or where you have the timing set.

Note: Always verify timing with a timing light.

Chevy/Chrysler

- Clockwise Rotation

Ford

Counterclockwise

Rotation

6. Install the cap and spark plug wires.

Recommendation: It is recommended on Chevrolet

applications to put the number one cylinder in the

position shown in Figure 4. The custom wire sets MSD

offers are designed for this setup.

Figure 3 Positioning the Rotor Tip.

Figure 4 Recommended Chevrolet

Installation Position.

Cylinder

Location

Figure 5 Chevy Blocks must be modified to accept O-rings.

Note: Block must be modified to use O-Rings.

Chevrolet PN 7908 and PN 79083 only: Install

the gasket and apply a liberal amount of the

supplied lubricant to the distributor gear and

O-rings. (The supplied O-rings can

only be

used if the block has been modified as shown

in Figure 5.)

PN79082 Datasheet(PDF) 2 Page - Mallory performance club