EM78P447SAM datasheet(14/55 Pages) EMC

14 / 55 page

EM78P447S

OTP ROM

1: Enable open-drain output.

The ODE bit can be read and written.

• Bit 5 (WDTE) Control bit used to enable Watchdog timer.

The WDTE bit is useful only when ENWDT, the CODE Option bit, is "0". It is only when the ENWDT

bit is "0" that WDTE bit. is able to disabled/enabled the WDT.

0: Disable WDT.

1: Enable WDT.

The WDTE bit is not used if ENWDT, the CODE Option bit ENWDT, is "1". That is, if the ENWDT bit

is "1", WDT is always disabled no matter what the WDTE bit status is.

The WDTE bit can be read and written.

• Bit 4 (SLPC) This bit is set by hardware at the low level trigger of wake-up signal and is cleared by

software. SLPC is used to control the oscillator operation. The oscillator is disabled (oscillator is

stopped, and the controller enters into SLEEP2 mode) on the high-to-low transition and is enabled

(controller is awakened from SLEEP2 mode) on low-to-high transition. In order to ensure the stable

output of the oscillator, once the oscillator is enabled again, there is a delay for approximately 18ms

(oscillator start-up timer, OST) before the next instruction of the program is executed. The OST is

always activated by a wake-up event from sleep mode regardless of the Code Option bit ENWDT

status is "0" or otherwise. After waking up, the WDT is enabled if the Code Option ENWDT is "1". The

block diagram of SLEEP2 mode and wake-up invoked by an input trigger is depicted in Fig. 5. The

SLPC bit can be read and written.

• Bit 3 (ROC) ROC is used for the R-option. Setting ROC to "1" will enable the status of R-option pins

(P70, P71) for the controller to read. Clearing ROC will disable the R-option function. Otherwise, the

R-option function is introduced. Users must connect the P71 pin or/and P70 pin to VSS with a

430K

Ω external resistor (Rex). If Rex is connected/disconnected with VDD, the status of P70 (P71)

will be read as "0"/"1" (refer to Fig. 7(b)). The ROC bit can be read and written.

• Bit 0 (/WUE) Control bit is used to enable the wake-up function of P74 and P75.

0: Enable the wake-up function.

1: Disable the wake-up function.

The /WUE bit can be read and written.

• Bits 1~2, and 7 Not used.

1 <Note>: Vdd = 5V, set up time period = 16.2ms ± 30%

Vdd = 3V, set up time period = 19.6ms ± 30%

This specification is subject to change without prior notice.

06.25.2003 (V1.1)

EM78P447SAM Datasheet(PDF) 14 Page - ELAN Microelectronics Corp