LPS33HW datasheet(17/50 Pages) STMICROELECTRONICS

Part #	LPS33HW

Description	MEMS pressure sensor: 260-1260 hPa absolute digital output barometer with water-resistant package

PDF	50 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

17 / 50 page

DocID030522 Rev 1

17/50

LPS33HW

FIFO

4.2

FIFO mode

In FIFO mode (FIFO_CTRL (14h)(FMODE2:0) = 001) data from the output PRESS_OUT_H

(2Ah), PRESS_OUT_L (29h), PRESS_OUT_XL (28h) and TEMP_OUT_H (2Ch),

TEMP_OUT_L (2Bh) are stored in the FIFO until it is overwritten.

To reset FIFO content, Bypass mode the value '000' must be written in FIFO_CTRL

(14h)(FMODE2:0). After this reset command it is possible to restart FIFO mode writing the

value '001' in FIFO_CTRL (14h)(FMODE2:0).

FIFO buffer memorizes 32 levels of data but the depth of the FIFO can be resized by setting

the CTRL_REG2 (11h)(STOP_ON_FTH) bit. If the STOP_ON_FTH bit is set to '1', FIFO

depth is limited to FIFO_CTRL (14h)(WTM4:0) + 1 data.

A FIFO threshold interrupt can be enabled (F_OVR bit in CTRL_REG3 (12h) in order to be

raised when the FIFO is filled to the level specified by the WTM4:0 bits of FIFO_CTRL

(14h). When a FIFO threshold interrupt occurs, the first data has been overwritten and the

FIFO stops collecting data from the input pressure and temperature.

Figure 7. FIFO mode

LPS33HW Datasheet(PDF) 17 Page - STMicroelectronics