3

q Display Selection (Access Mode: EASY)

Excess

gain

Output

status

Power

mode status

PV

CV

Press

Press

CV

Press

• The CV is displayed in

percent based on the

PV.

• The current value will be

displayed if no keys are operated

for approximately 30 s.

• If the timer function is set, the

output status with power mode

and the timer mode with set time

will be displayed alternately.

q Display Selection (Access Mode: FULL)

Press

Press

CV

Peak value

Bottom value

LED bar

indicator

Output

status

Peak

excess

gain

Bottom

excess

gain

Power

mode status

Press

Press

Press

Press

Excess

gain

PV

CV

CV

q Menu Selection (Access Mode: EASY)

Access mode

selection

Power mode

selection

Timer function

setting

Press

Press manual

button to select

Press manual

button to select

Press the

mode button 3 s min

Press

Other than

FINE

TURBO

SUPER

TURBO

Press

Press

Press to manual button to

make timer adjustments

* For timer values, refer to the

corresponding table under FULL

mode.

Normal

operation use

Timer OFF (for

normal operation use)

OFF-delay timer

ON-delay timer

One-shot timer

Used if the sensing

distance is insufficient

while the sensor is in

fine mode.

Used if the sensing

environment is bad

due to dust or other

obstacles.

q Menu Selection (Access Mode: FULL)

Press the

mode button 3 s min

Access

mode

selection

Power

mode

selection

Select

Select

Select

Select

Edge

detection

mode

selection

Select

Select

S-APC

mode

setting

FINE

TURBO

SUPERTURBO

ULTRATURBO

HIGHSPEED

HIGH RESO-

LUTION

Timer

function

setting

Power save

function

setting

Shift

function

setting

Press

Press

Press

Used to detect sensing objects highly

precisely under clean environments.

OFF (for normal operation use)

Rising edge

Falling edge

OFF (for normal operation use)

ECO half

ECO all

OFF (for normal operation use)

Shift ON

OFF (for normal operation use)

Press

Timer adjustments

* A maximum error of

±10% of the PV.

Timer adjustment range

Press

Press

Press

Press

Press

Shift value

CV

Shift value adjustment

1~30ms

30~50ms

50~200ms

200~500ms

1-ms increments

2-ms increments

10-ms increments

50-ms increments

Power mode

,

Other than

Power mode

,

Other than

Power mode

Power mode

Other than

Normal operation use

Used if the incident is insufficient while

the sensor is in SUPER TURBO mode.

Used to detect sensing objects

moving at high speed.

Used to detect delicate differences

within a short sensing distance.

Timer OFF (for normal operation use)

OFF-delay timer

ON-delay timer

One-shot timer

Used if the sensing distance is insufficient

while the sensor is in fine mode.

Used if the sensing environment is

bad due to dust or other obstacles.

Sensitivity Settings in Edge Detection Mode

The sensitivity of the sensor will be set to maximum by pressing the

while the sensor is in edge detection mode. Make fine sensitivity adjust-

ments by pressing the

.

Note:

• Press the mode button (

) for a minimum of three seconds to return to the display of the CV from any menu selection stage. To return to the

previous display, press the mode button (

) first, and press the left side (

) of the manual button (

).

• When the power mode is set to HIGH RESOLUTION, the S-APC mode will be always turned ON.

• When the power mode is set to HIGH SPEED, the S-APC mode will be always turned ON in the case of the R model, or otherwise the S-APC mode

will be always turned OFF.