WM8766 datasheet(18/36 Pages) WOLFSON

18 / 36 page

WM8766

Production Data

PD Rev 4.1 July 2005

DSP MODE A

In DSP mode A, the MSB of DAC channel 1 left data is sampled by the WM8766 on the second

rising edge on BCLK following a LRCLK rising edge. DAC channel 1 right and DAC channels 2 and 3

data follow DAC channel 1 left data (Figure 16).

Figure 16 DSP Mode A Timing Diagram – DAC Data Input

DSP MODE B

In DSP mode B, the MSB of DAC channel 1 left data is sampled by the WM8766 on the first BCLK

rising edge following a LRCLK rising edge. DAC channel 1 right and DAC channels 2 and 3 data

follow DAC channel 1 left data (Figure 17).

Figure 17 DSP Mode B Timing Diagram – DAC Data Input

In both DSP modes A and B, DACL1 is always sent first, followed immediately by DACR1 and the

data words for the other 6 channels. No BCLK edges are allowed between the data words. The word

order is DAC1 left, DAC1 right, DAC2 left, DAC2 right, DAC3 left, DAC3 right.

POWERDOWN MODES

The WM8766 has powerdown control bits allowing specific parts of the WM8766 to be powered off

when not being used.

The three stereo DACs each have a separate powerdown control bit,

DACPD[2:0] allowing individual stereo DACs to be powered off when not in use. Setting DACPD[2:0]

will powerdown everything except the reference VMID may be powered down by setting PDWN.

Setting PDWN will override all other powerdown control bits. It is recommended that the DACs are

powered down before setting PDWN.

WM8766 Datasheet(PDF) 18 Page - Wolfson Microelectronics plc