SST26VF032B-104ISLASHSM datasheet(1/82 Pages) MICROCHIP

Part #	SST26VF032B-104I/SM

Description	2.5V/3.0V 32-Mbit Serial Quad I/O™ (SQI™) Flash Memory

PDF	82 Pages

Scroll/Zoom	100%

Manufacturer	MICROCHIP [Microchip Technology]

Direct Link	http://www.microchip.com

Logo

1 / 82 page

 2013-2022 Microchip Technology Inc. and its subsidiaries

DS20005218K-page 1

Features

• Single Voltage Read and Write Operations:

- 2.7V-3.6V or 2.3V-3.6V

• Serial Interface Architecture:

- Nibble-wide multiplexed I/O’s with SPI-like serial

command structure

- Mode 0 and Mode 3

- x1/x2/x4 Serial Peripheral Interface (SPI) Protocol

• High-Speed Clock Frequency:

- 2.7V-3.6V: 104 MHz maximum

- 2.3V-3.6V: 80 MHz maximum

• Burst Modes:

- Continuous linear burst

- 8/16/32/64 Byte linear burst with wrap-around

• Superior Reliability:

- Endurance: 100,000 Cycles (minimum)

- Greater than 100 years Data Retention

• Low-Power Consumption:

- Active Read current: 15 mA (typical @ 104 MHz)

- Standby Current: 15 µA (typical)

• Fast Erase Time:

- Sector/Block Erase: 18 ms (typ), 25 ms

(maximum)

- Chip Erase: 35 ms (typical), 50 ms (maximum)

• Page-Program:

- 256 bytes per page in x1 or x4 mode

• End-of-Write Detection:

- Software polling BUSY bit in STATUS register

• Flexible Erase Capability:

- Uniform 4-Kbyte sectors

- Four 8-KByte top and bottom parameter overlay

blocks

- One 32-Kbyte top and bottom overlay block

- Uniform 64-Kbyte overlay blocks

• Write-Suspend:

- Suspend Program or Erase operation to access

another block/sector

• Software Reset (RST) mode

• Software Write Protection:

- Individual-Block Write Protection with permanent

lock-down capability

- 64-Kbyte blocks, two 32-Kbyte blocks, and

eight 8-Kbyte parameter blocks

- Read Protection on top and bottom 8-Kbyte

parameter blocks

• Security ID:

- One-Time Programmable (OTP) 2-KByte, Secure ID:

- 64-bit unique, factory preprogrammed identifier

- User-programmable area

• Temperature Range:

- Industrial: -40°C to +85°C

- Industrial Plus: -40°C to +105°C

- Extended: -40°C to +125°C

• Automotive AEC-Q100 Grade 1, Grade 2 and

Grade 3

• Packages Available:

- 8-contact WDFN (6 mm x 5 mm)

- 8-lead SOIJ (5.28 mm)

- 24-ball TBGA (6 mm x 8 mm)

• All Devices are RoHS Compliant

Product Description

The Serial Quad I/O™ (SQI™) family of Flash memory

devices features a six-wire, 4-bit I/O interface that allows for

low-power, high-performance operation in a low pin-count

package. SST26VF032B/032BA also support full com-

mand-set compatibility to traditional Serial Peripheral Inter-

face (SPI) protocol. System designs using SQI Flash

devices occupy less board space and ultimately lower

system costs.

All members of the 26 Series, SQI family are manufactured

with proprietary, high-performance CMOS SuperFlash®

technology. The split-gate cell design and thick-oxide tun-

neling injector attain better reliability and manufacturability

compared with alternate approaches.

SST26VF032B/032BA significantly improve performance

and reliability, while lowering power consumption. These

devices write (Program or Erase) with a single power supply

of 2.3-3.6V. The total energy consumed is a function of the

applied voltage, current, and time of application. Since for

any given voltage range, the SuperFlash technology uses

less current to program and has a shorter erase time, the

total energy consumed during any Erase or Program opera-

tion is less than alternative Flash memory technologies.

Two

configurations

are

available

upon

order.

SST26VF032B default at power-up has the WP# and

HOLD# pins enabled, and the SIO2 and SIO3 pins

disabled, to initiate SPI-protocol operations.

SST26VF032BA default at power-up has the WP#

and HOLD# pins disabled, and the SIO2 and SIO3

pins enabled, to initiate Quad I/O operations. See

Section 4.5.8 “I/O Configuration (IOC)” for more

information about configuring WP#/HOLD# and SIO2/

SIO3 pins. See Figure 2-1 for pin assignments.

SST26VF032B/SST26VF032BA

2.5V/3.0V 32-Mbit Serial Quad I/O™ (SQI™) Flash Memory

Similar Part No. - SST26VF032B-104I/SM

Manufacturer	Part #	Datasheet	Description
Microchip Technology	SST26VF032B-104I/SM	927Kb / 77P	2.5V/3.0V 32 Mbit Serial Quad I/O (SQI) Flash Memory 07/14/15

More results

Similar Description - SST26VF032B-104I/SM

Manufacturer	Part #	Datasheet	Description
Microchip Technology	SST26VF064B	1Mb / 76P	3.0V Serial Quad I/O (SQI) Flash Memory 2013
Silicon Storage Technol...	SST26VF016	386Kb / 39P	Serial Quad I/O SQI Flash Memory
Microchip Technology	SST26VF064B	3Mb / 85P	2.5V/3.0V 64 Mbit Serial Quad I/O (SQI) Flash Memory 07/14/15
	SST26VF032B	927Kb / 77P	2.5V/3.0V 32 Mbit Serial Quad I/O (SQI) Flash Memory 07/14/15
	SST26VF016B	2Mb / 77P	2.5V/3.0V 16 Mbit Serial Quad I/O (SQI) Flash Memory 01/27/15
	SST26VF080A	792Kb / 72P	2.5V/3.0V 8-Mbit Serial Quad I/O??(SQI?? Flash Memory 02/28/20
	SST26VF040A	781Kb / 73P	2.5V/3.0V 4-Mbit Serial Quad I/O??(SQI?? Flash Memory 02/28/20
	SST26VF064B	1Mb / 90P	2.5V/3.0V 64-Mbit Serial Quad I/O??(SQI?? Flash Memory 09/14/21
	SST26VF020A	2Mb / 74P	2.5V/3.0V 2-Mbit Serial Quad I/O™ (SQI™) Flash Memory Revision C / October 2021
	SST26VF032BEUI	3Mb / 76P	32 Mbit Serial Quad I/O (SQI) Flash Memory with EUI-48™ and EUI-64™ Identifier Revision A / Jan 2019

More results

SST26VF032B-104I/SM Datasheet(PDF) 1 Page - Microchip Technology

SST26VF032B-104I/SM Datasheet(HTML) 1 Page - Microchip Technology

Similar Part No. - SST26VF032B-104I/SM

Similar Description - SST26VF032B-104I/SM

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82

Datasheet Download

Link URL