H8SXSLASH1663M datasheet(1133/1504 Pages) RENESAS

1133 / 1504 page

Section 23 D/A Converter

Rev. 2.00 Sep. 24, 2008 Page 1101 of 1468

REJ09B0412-0200

23.4

Operation

The D/A converter includes D/A conversion circuits for two channels, each of which can operate

independently. When the DAOE bit in DACR01 is set to 1, D/A conversion is enabled and the

conversion result is output.

An operation example of D/A conversion on channel 0 is shown below. Figure 23.2 shows the

timing of this operation.

1. Write the conversion data to DADR0.

2. Set the DAOE0 bit in DACR01 to 1 to start D/A conversion. The conversion result is output

from the analog output pin DA0 after the conversion time t

DCONV has elapsed. The conversion

result continues to be output until DADR0 is written to again or the DAOE0 bit is cleared to 0.

The output value is expressed by the following formula:

Contents of DADR/256

× V

ref

3. If DADR0 is written to again, the conversion is immediately started. The conversion result is

output after the conversion time t

DCONV has elapsed.

4. If the DAOE0 bit is cleared to 0, analog output is disabled.

Conversion data 1

Conversion

result 1

High-impedance state

tDCONV

DADR0

write cycle

DA0

DAOE0

DADR0

Address

DACR01

write cycle

Conversion data 2

Conversion

result 2

tDCONV

[Legend]

tDCONV: D/A conversion time

DADR0

write cycle

DACR01

write cycle

Figure 23.2 Example of D/A Converter Operation

H8SX/1663M Datasheet(PDF) 1133 Page - Renesas Technology Corp

H8SX/1663M Datasheet(HTML) 1133 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL