M32CSLASH86 datasheet(251/505 Pages) RENESAS

251 / 505 page

Page 228

17. Serial I/O (Special Function)

)

(

If the output signal level of the TxDi pin (i=0 to 4) differs from the input signal level of the RxDi pin, an

interrupt request is generated.

UART0 and UART3 are assigned software interrupt number 40. UART1 and UART4 are assigned number

41. When using the bus conflict detect function of UART0 or UART3, of UART1 or UART4, set the IFSR6

bit and the IFSR7 bit in the IFSR register accordingly.

When the ABSCS bit in the UiSMR register is set to "0" (rising edge of the transfer clock), it is determined,

on the rising edge of the transfer clock, if the output level of the TxD pin and the input level of the RxD pin

match. When the ABSCS bit is set to "1" (timer Aj underflow), it is determined when the timer Aj (timer A3

in UART0, timer A4 in UART1, timer A0 in UART2, timer A3 in UART3, the timer A4 in UART4) counter

overflows. Use the timer Aj in one-shot timer mode.

When the ACSE bit in the UiSMR register is set to "1" (automatic clear at bus conflict) and the IR bit in the

BCNiIC register to "1" (discrepancy detected), the TE bit in the UiC1 register is set to "0" (transmit disable).

When the SSS bit in the UiSMR register is set to "1" (synchronized with RxDi), data is transmitted from the

TxDi pin on the falling edge of the RxDi pin. Figure 17.28 shows bits associated with the bus conflict detect

function.

M32C/86 Datasheet(PDF) 251 Page - Renesas Technology Corp