ATmega162 datasheet(157/324 Pages) ATMEL

157 / 324 page

157

2513K–AVR–07/09

ATmega162/V

Serial

Peripheral

Interface – SPI

The Serial Peripheral Interface (SPI) allows high-speed synchronous data transfer between the

ATmega162 and peripheral devices or between several AVR devices. The ATmega162 SPI

includes the following features:

• Full-duplex, Three-wire Synchronous Data Transfer

• Master or Slave Operation

• LSB First or MSB First Data Transfer

• Seven Programmable Bit Rates

• End of Transmission Interrupt Flag

• Write Collision Flag Protection

• Wake-up from Idle Mode

• Double Speed (CK/2) Master SPI Mode

Figure 71. SPI Block Diagram

(1)

Note:

1. Refer to Figure 1 on page 2, and Table 32 on page 72 for SPI pin placement.

The interconnection between Master and Slave CPUs with SPI is shown in Figure 72. The sys-

tem consists of two Shift Registers, and a Master clock generator. The SPI Master initiates the

communication cycle when pulling low the Slave Select SS pin of the desired Slave. Master and

Slave prepare the data to be sent in their respective Shift Registers, and the Master generates

the required clock pulses on the SCK line to interchange data. Data is always shifted from Mas-

ter to Slave on the Master Out – Slave In, MOSI, line, and from Slave to Master on the Master In

– Slave Out, MISO, line. After each data packet, the Master will synchronize the Slave by pulling

high the Slave Select, SS, line.

When configured as a Master, the SPI interface has no automatic control of the SS line. This

must be handled by user software before communication can start. When this is done, writing a

DIVIDER

/2/4/8/16/32/64/128

ATmega162 Datasheet(PDF) 157 Page - ATMEL Corporation