WM9093ECSSLASHR datasheet(40/84 Pages) WOLFSON

40 / 84 page

WM9093

Production Data

PD, March 2012, Rev 4.2

CONTROL WRITE SEQUENCER

The Control Write Sequencer is a programmable unit that forms part of the WM9093 control interface

logic. It provides the ability to perform a sequence of register write operations with the minimum of

demands on the host processor – the sequence may be initiated by a single operation from the host

processor and then left to execute independently.

Default sequences for Start-Up of each output driver and Shut-Down are provided (see “Default

Sequences” section). It is recommended that these default sequences are used unless changes

become necessary.

When a sequence is initiated, the sequencer performs a series of pre-defined register writes. The

host processor informs the sequencer of the start index of the required sequence within the

sequencer’s memory. At each step of the sequence, the contents of the selected register fields are

read from the sequencer’s memory and copied into the WM9093 control registers. This continues

sequentially through the sequencer’s memory until an “End of Sequence” bit is encountered; at this

point, the sequencer stops and an Interrupt status flag is asserted. For cases where the timing of the

write sequence is important, a programmable delay can be set for specific steps within the sequence.

Note that the Control Write Sequencer’s internal clock is derived from the internal clock CLK_SYS

which must be enabled by setting OSC_ENA (see “Clocking Control”). The clock division from

CLK_SYS is handled transparently by the WM9093 without user intervention.

INITIATING A SEQUENCE

The Register fields associated with running the Control Write Sequencer are described in Table 19.

Note that the operation of the Control Write Sequencer also requires the internal clock CLK_SYS to

be enabled via the OSC_ENA control bit (see “Clocking Control”).

The Write Sequencer is enabled by setting the WSEQ_ENA bit. The start index of the required

sequence must be written to the WSEQ_START_INDEX field. Setting the WSEQ_START bit initiates

the sequencer at the given start index.

The Write Sequencer can be interrupted by writing a logic 1 to the WSEQ_ABORT bit.

The current status of the Write Sequencer can be read using two further register fields – when the

WSEQ_BUSY bit is asserted, this indicates that the Write Sequencer is busy. Note that, whilst the

Control Write Sequencer is running a sequence (indicated by the WSEQ_BUSY bit), normal

read/write operations to the Control Registers cannot be supported. The index of the current step in

the Write Sequencer can be read from the WSEQ_CURRENT_INDEX field; this is an indicator of the

sequencer’s progress. On completion of a sequence, this field holds the index of the last step within

the last commanded sequence.

WM9093ECS/R Datasheet(PDF) 40 Page - Wolfson Microelectronics plc