MPC875CVR133 datasheet(16/84 Pages) FREESCALE

16 / 84 page

MPC875/MPC870 PowerQUICC™ Hardware Specifications, Rev. 4

Freescale Semiconductor

Layout Practices

10 Layout Practices

Each VDD pin on the MPC875/MPC870 should be provided with a low-impedance path to the board’s

supply. Each GND pin should likewise be provided with a low-impedance path to ground. The power

supply pins drive distinct groups of logic on chip. The V

DD power supply should be bypassed to ground

using at least four 0.1-µF bypass capacitors located as close as possible to the four sides of the package.

Each board designed should be characterized and additional appropriate decoupling capacitors should be

used if required. The capacitor leads and associated printed-circuit traces connecting to chip VDD and

GND should be kept to less than half an inch per capacitor lead. At a minimum, a four-layer board

employing two inner layers as VDD and GND planes should be used.

All output pins on the MPC875/MPC870 have fast rise and fall times. Printed circuit (PC) trace

interconnection length should be minimized in order to minimize undershoot and reflections caused by

these fast output switching times. This recommendation particularly applies to the address and data buses.

Maximum PC trace lengths of 6 inches are recommended. Capacitance calculations should consider all

device loads as well as parasitic capacitances due to the PC traces. Attention to proper PCB layout and

bypassing becomes especially critical in systems with higher capacitive loads because these loads create

higher transient currents in the VDD and GND circuits. Pull up all unused inputs or signals that will be

inputs during reset. Special care should be taken to minimize the noise levels on the PLL supply pins. For

more information, refer to Section 14.4.3, “Clock Synthesizer Power (VDDSYN, VSSSYN, VSSSYN1),” in

the MPC885 PowerQUICC™ Family Reference Manual.

PADIR (Port A data direction register)

PADIR[5:9]

PADIR[12:13]

PBPAR (Port B pin assignment register)

PBPAR[14:18]

PBPAR[20:22]

PBDIR (Port B data direction register)

PBDIR[14:8]

PBDIR[20:22]

PCPAR (Port C pin assignment register)

PCPAR[4:5]

PCPAR[8:9]

PCPAR[14]

PCDIR (Port C data direction register)

PCDIR[4:5]

PCDIR[8:9]

PCDIR[14]

PDPAR (Port D pin assignment register)

PDPAR[3:7]

PDPAR[9:5]

PDDIR (Port D data direction register)

PDDIR[3:7]

PDDIR[9:15]

Table 7. Mandatory Reset Configuration of MPC875/MPC870 (continued)

Field

Value

(Binary)

MPC875CVR133 Datasheet(PDF) 16 Page - Freescale Semiconductor, Inc

MPC875CVR133 Datasheet(HTML) 16 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

Datasheet Download

Link URL