AT86RF211DAI-R datasheet(12/48 Pages) ATMEL

12 / 48 page

AT86RF211

1942C–WIRE–06/02

Figure 11. Schematic Input of the LNA

Figure 12. Schematic Output of the Mixer

The first mixer translates the input RF signal down to 10.7 MHz or 21.4 MHz as chosen

by the user. The local oscillator is provided by the same synthesizer which will generate

a local frequency 10.7 MHz or 21.4 MHz away from the Tx carrier frequency.

The output impedance of the mixer is 330

Ω with a 20% accuracy, so that low cost, stan-

dard 10.7 MHz ceramic filters can be directly driven. Other IFs may be chosen thanks to

the high bandwidth (50 MHz) of the mixer.

IF1 filtering

A popular ceramic filter is used to reject the second image frequency and provide a first

level of filtering.

The IF1 filter can however be removed; it leads to a sensitivity reduction of about 3 dB

(the substitution coupling capacitor should be > 100 pF).

IF1 Gain and Second Mixer

The input impedance of the IF1 amplifier is naturally 330

Ω to match the input filter. The

voltage gain, i.e. gain at 10.7 MHz or 21.4 MHz added to the conversion gain at 455 kHz

is typically 14 dB when loaded by 1700

Ω. The second mixer operates at a fixed LO fre-

quency of 10.245 MHz or 20.945 MHz. Its output impedance is 1700

Ω in parallel with 20

pF.

RXIN

IF1OUT

AT86RF211DAI-R Datasheet(PDF) 12 Page - ATMEL Corporation