CS5451 datasheet(9/14 Pages) ETC

9 / 14 page

CS5451

DS458PP4

enable) input is held high. Otherwise, these outputs

will be high impedance.

Data out (SDO) changes as a result of SCLK fall-

ing, and always outputs valid data with SCLK ris-

ing. When data is being transferred, the SCLK

frequency is either 1/8 of the XIN input frequency

(when OWRS is held low) or 1/4 of the XIN input

frequency (when OWRS is held high). Any other

time, SCLK is held low. (See Figures 3 and 4.)

The framing signal (FSO) output is normally low,

but produces a high level pulse lasting one SCLK

period when the instantaneous voltage/current data

samples are about to be transmitted out of the serial

interface (after each A/D conversion cycle). Note:

SCLK is not active during FSO high.

For 96 SCLK periods after FSO falls, SCLK is ac-

tive and SDO produces valid output. Six channels

of 16 bit data are output, MSB first. Voltage and

current measurements are output (in that order) for

three phases. SCLK will then be held low until the

next sample period.

2.5

System Initialization

When power to the CS5451 is applied, the chip

must be held in a reset condition using the RESET

input.

A hardware reset is initiated when the RESET pin

is forced low with a minimum pulse width of 50 ns.

2.6

Analog Inputs

The analog inputs of the CS5451 are bipolar volt-

age inputs: Three voltage channel inputs VIN(1-3)

and three current channel inputs IIN(1-3). The

CS5451 accommodates a full scale range of

40 mV or ±800 mV on the Current Channels and

800 mV on the Voltage Channels.

2.7

Voltage Reference

The CS5451 is specified for operation with a +1.2

V reference between the VREFIN and AGND pins.

The converter includes an internal 1.2 V reference

(50 ppm/°C drift) that can be used by connecting

the VREFOUT pin to the VREFIN pin of the de-

vice. If higher accuracy/stability is required, an ex-

ternal reference can be used.

2.8

Power Supply

The low, stable analog power consumption and su-

perior supply rejection of the CS5451 allow for the

use of a simple charge-pump negative supply gen-

erator. The use of a negative supply alleviates the

need for level shifting of the analog inputs. The

CPD pin and capacitor C1 provide the necessary

analog supply current as shown in Figure 5. The

Schottky diodes D1 and D2 are chosen for their low

forward voltages and high-speed capabilities. The

capacitor C2 provides the required charge storage

and bypassing of the negative supply. The CPD

output signal provides the charge pump driver sig-

SCLK

FSO

SDO

13 12 11 10 9

321

Channel 1 (I )

Channel 1 ( V )

015 14

. . .

Ch. 2 ( V ) Ch. 2 ( I ) Ch. 3 ( V ) Ch. 3 ( I )

...

. . .

[ Undefined ]

. . .

96 SCLKs

Figure 4. Close-up of One Data Frame

CS5451 Datasheet(PDF) 9 Page - List of Unclassifed Manufacturers

CS5451 Datasheet(HTML) 9 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Datasheet Download

Link URL