HLMP-EL15-RU000 datasheet(7/12 Pages) HP

7 / 12 page

Electrical/Optical Characteristics at TA = 25°C

Parameter

Symbol

Min.

Typ.

Max.

Units

Test Conditions

Forward Voltage

IF = 20 mA

Amber (

d = 590 nm)

2.02

Orange (

d = 605 nm)

1.98

2.4

Red-Orange (

d = 615 nm)

1.94

Red (

d = 626 nm)

1.90

Reverse Voltage

520

IF = 100 µA

Peak Wavelength:

Peak of Wavelength of

Amber (

d = 590 nm)

592

Spectral Distribution

Orange (

d = 605 nm)

PEAK

609

at IF = 20 mA

Red-Orange (

d = 615 nm)

621

Red (

d = 626 nm)

635

Spectral Halfwidth

∆λ

1/2

Wavelength Width at

Spectral Distribution

1/2 Power Point at

IF = 20 mA

Speed of Response

Exponential Time

Constant, e-t/τ

Capacitance

VF = 0, f = 1 MHz

Thermal Resistance

J-PIN

240

°C/W

LED Junction-to-Cathode

Lead

Luminous Efficacy[1]

Emitted Luminous

Amber (

d = 590 nm)

480

Power/Emitted Radiant

Orange (

d = 605 nm)

370

lm/W

Power

Red-Orange (

d = 615 nm)

260

Red (

d = 626 nm)

150

Note:

1. The radiant intensity, Ie, in watts per steradian, may be found from the equation Ie = Iv/ηv, where Iv is the luminous intensity in

candelas and

v is the luminous efficacy in lumens/watt.

Absolute Maximum Ratings at TA = 25°C

DC Forward Current[1,2,3] ............................................................ 50 mA

Peak Pulsed Forward Current[2,3] .............................................. 100 mA

Average Forward Current[3] ......................................................... 30 mA

Reverse Voltage (IR = 100 µA) ......................................................... 5 V

LED Junction Temperature .......................................................... 130

°C

Operating Temperature .............................................. -40

°C to +100°C

Storage Temperature .................................................. -40

°C to +120°C

Dip/Drag Soldering Temperature ........................... 260

°C for 6 seconds

Through-the-Wave Preheat Temperature ...................................... 145

°C

Through-the-Wave Solder Temperature ................. 245

°C for 3 seconds

[1.59 mm (0.060 in.) below seating plane]

Notes:

1. Derate linearly as shown in Figure 4.

2. For long term performance with minimal light output degradation, drive currents

between 10 mA and 30 mA are recommended. For more information on recommended

drive conditions, please refer to HP Application Brief I-024 (5966-3087E).

3. Please contact your Hewlett-Packard sales representative about operating currents

below 10 mA.

HLMP-EL15-RU000 Datasheet(PDF) 7 Page - Agilent(Hewlett-Packard)

HLMP-EL15-RU000 Datasheet(HTML) 7 Page - Agilent(Hewlett-Packard)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

Datasheet Download

Link URL