USB3450 datasheet(20/40 Pages) SMSC

20 / 40 page

Hi-Speed USB Host or Device PHY With UTMI+ Interface

Datasheet

Revision 0.1 (05-11-05)

SMSC USB3450

DATASHEET

Chapter 6 Detailed Functional Overview

Figure 2.1 on page 9 shows the functional block diagram of the USB3450. Each of the functions is

described in detail below.

6.1

8bit Bi-Directional Data Bus Operation

The USB3450 supports an 8-bit bi-directional parallel interface.

■

CLKOUT runs at 60MHz

■

The 8-bit data bus (DATA[7:0]) is used for transmit when TXVALID = 1

■

The 8-bit data bus (DATA[7:0]) is used for receive when TXVALID = 0

Figure 6.1 shows the relationship between CLKOUT and the transmit data transfer signals in FS mode.

TXREADY is only asserted for one CLKOUT per byte time to signal the Link that the data on the DATA

lines has been read by the PHY. The Link may hold the data on the DATA lines for the duration of the

byte time. Transitions of TXVALID must meet the defined setup and hold times relative to CLKOUT.

Figure 6.2 shows the relationship between CLKOUT and the receive data control signals in FS mode.

RXACTIVE “frames” a packet, transitioning only at the beginning and end of a packet. However

transitions of RXVALID may take place any time 8 bits of data are available. Figure 6.2 also shows

how RXVALID is only asserted for one CLKOUT cycle per byte time even though the data may be

presented for the full byte time. The XCVRSELECT signal determines whether the HS or FS timing

relationship is applied to the data and control signals.

Figure 6.1 FS CLK Relationship to Transmit Data and Control Signals

Figure 6.2 FS CLK Relationship to Receive Data and Control Signals

USB3450 Datasheet(PDF) 20 Page - SMSC Corporation