ST10F276 datasheet(53/229 Pages) STMICROELECTRONICS

53 / 229 page

ST10F276

Bootstrap loader

53/229

5.2.7

Exiting bootstrap loader mode

To execute a program in normal mode, the BSL mode must first be terminated. The

ST10F276 exits BSL mode at a software reset (level on P0L.4 is ignored) or a hardware

reset (P0L.4 must be high in this case). After the reset, the ST10F276 starts executing from

location 00’0000H of the internal Flash (User Flash) or the external memory, as programmed

via pin EA.

Note:

If a bidirectional Software Reset is executed and external memory boot is selected (EA =0),

a degeneration of the Software Reset event into a Hardware Reset can occur (refer to

section for details). This implies that P0L.4 becomes transparent, so to exit from Bootstrap

mode it would be necessary to release pin P0L.4 (it is no longer ignored).

5.2.8

Hardware requirements

Although the new bootstrap loader is designed to be compatible with the old bootstrap

loader, there are a few hardware requirements relative to the new bootstrap loader:

–

External Bus configuration: Must have four or less segment address lines (keep

CAN I/Os available);

–

Usage of CAN pins (P4.5 and P4.6): Even in bootstrap via UART, P4.5

(CAN1_RxD) can be used as Port input but not as output. The pin P4.6

(CAN1_TxD) can be used as input or output.

–

Level on UART RxD and CAN1_RxD during the bootstrap phase (see Figure 6 -

Step 2): Must be 1 (external pull-ups recommended).

5.3

Standard bootstrap with UART (RS232 or K-Line)

5.3.1

Features

ST10F276 bootstrap via UART has the same overall behavior as the old ST10 bootstrap via

UART:

●

Same bootstrapping steps;

●

Same bootstrap method: Analyze the timing of a predefined byte, send back an

acknowledge byte, load a fixed number of bytes and run;

●

Same functionalities: Boot with different crystals and PLL ratios.

ST10F276 Datasheet(PDF) 53 Page - STMicroelectronics

ST10F276 Datasheet(HTML) 53 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL