AT80C51RA2-RLSIV datasheet(55/86 Pages) ATMEL

55 / 86 page

4188F–8051–01/08

AT/TS8xC51Rx2

Figure 9-1.

Set-Up Modes Configuration

9.3.3

Programming Algorithm

The Improved Quick Pulse algorithm is based on the Quick Pulse algorithm and decreases the

number of pulses applied during byte programming from 25 to 1.

To program the TS87C51RB2/RC2/RD2 the following sequence must be exercised:

• Step 1: Activate the combination of control signals.

• Step 2: Input the valid address on the address lines.

• Step 3: Input the appropriate data on the data lines.

• Step 4: Raise EA/VPP from VCC to VPP (typical 12.75V).

• Step 5: Pulse ALE/PROG once.

• Step 6: Lower EA/VPP from VPP to VCC

Repeat step 2 through 6 changing the address and data for the entire array or until the end of

the object file is reached (See Figure 9-2).

9.3.4

Verify algorithm

Code array verify must be done after each byte or block of bytes is programmed. In either case,

a complete verify of the programmed array will ensure reliable programming of the

TS87C51RB2/RC2/RD2.

P 2.7 is used to enable data output.

To verify the TS87C51RB2/RC2/RD2 code the following sequence must be exercised:

• Step 1: Activate the combination of program and control signals.

• Step 2: Input the valid address on the address lines.

• Step 3: Read data on the data lines.

Repeat step 2 through 3 changing the address for the entire array verification (See Figure 9-2.)

+5V

VCC

P0.0-P0.7

P1.0-P1.7

P2.0-P2.5

P3.4-P3.5

VSS

GND

D0-D7

A0-A7

A8-A15

RST

EA/VPP

ALE/PROG

PSEN

P2.6

P2.7

P3.3

P3.7

P3.6

XTAL1

4 to 6 MHz

CONTROL SIGNALS*

PROGRAM SIGNALS*

* See Table 31. for proper value on these inputs

AT80C51RA2-RLSIV Datasheet(PDF) 55 Page - ATMEL Corporation

AT80C51RA2-RLSIV Datasheet(HTML) 55 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86

Datasheet Download

Link URL