This document is the property of EM MICROELECTRONIC-MARIN SA and is furnished in confidence and upon the condition that all

rights originating in the information, whether patented or not, will be respected.

EM Document Center/04.08 - Page 1 of 17

SPECIFICATION FOR OLED MODULE TAT07

TABLE OF CONTENTS

1.

PURPOSE ..........................................................................................................................................................2

2.

PRODUCT SPECIFICATIONS...........................................................................................................................2

2.1

Module Revision and ordering number.....................................................................................................................2

2.2

Basic Specification ...................................................................................................................................................2

2.3

Mechanical Characteristics ......................................................................................................................................2

2.4

Absolute Maximum Ratings......................................................................................................................................2

2.5

Electrical Characteristics ..........................................................................................................................................3

2.6

LCD Electrical & Optical characteristics ...................................................................................................................3

2.6.1

Definition of optical characteristics ..........................................................................................................4

2.6.2

Definition of viewing angle.......................................................................................................................5

2.6.3

Definition of response time ......................................................................................................................5

2.7

Mechanical drawing..................................................................................................................................................6

2.7.1

Pin connection (signal function)...............................................................................................................7

3.

QUALIFICATION PROCEDURE .......................................................................................................................7

3.1

Tests to be performed on prototypes, preserie.........................................................................................................7

3.2

Packing reliability......................................................................................................................................................8

4.

MARKINGS ........................................................................................................................................................8

5.

SHIPMENT METHOD ........................................................................................................................................8

5.1

Internal Packaging....................................................................................................................................................8

6.

RECEIVING INSPECTION.................................................................................................................................8

7.

QUALITY ASSURANCE ....................................................................................................................................8

7.1

Conformity................................................................................................................................................................8

7.2

Responsibility ...........................................................................................................................................................8

7.3

Shipping Inspection Standards.................................................................................................................................9

7.3.1

Shipping Inspection Standards................................................................................................................9

7.3.2

Zone Definitions ......................................................................................................................................9

7.3.3

Visual Inspection .....................................................................................................................................9

7.3.4

Limit Sample............................................................................................................................................9

7.3.5

Individual Appearance Defects Standards (Back light ON and OFF / Display OFF) .............................10

7.3.6

Individual appearance defects standards (display ON) .........................................................................11

7.3.7

Chipped Glass Defect Standard ............................................................................................................12

7.3.8

FPC .......................................................................................................................................................13

8.

OPERATIONS PRECAUTIONS ......................................................................................................................14

8.1

Safety .....................................................................................................................................................................14

8.2

Handling .................................................................................................................................................................14

8.3

Mounting and Design .............................................................................................................................................14

8.4

Storage...................................................................................................................................................................14

8.5

Cleaning .................................................................................................................................................................14

9.

APPENDIX 1: PLASTIC TRAY DRAWING .....................................................................................................15

10.

APPENDIX 2: PALLET ASSEMBLY DRAWING ...........................................................................................16

11.

SPECIFICATION HISTORY.............................................................................................................................17

12.

ATTACHMENTS ..............................................................................................................................................17

13.

CUSTOMER APPROVAL ................................................................................................................................17