STM32L010K8 datasheet(75/92 Pages) STMICROELECTRONICS

75 / 92 page

DS12325 Rev 3

75/92

STM32L010K8 STM32L010R8

Electrical characteristics

Figure 23. ADC accuracy characteristics

Table 54. ADC accuracy(1)(2)(3)

Symbol

Parameter

Conditions

Min

Typ

Max

Unit

Total unadjusted error

1.8 V < VDDA < 3.6 V,

Range 1, 2 and 3

-2

LSB

Offset error

2.5

Gain error

Integral linearity error

1.5

2.5

Differential linearity error

1.5

ENOB

Effective number of bits

10.2

bits

Effective number of bits (16-bit mode

oversampling with ratio =256)(4)

11.3

12.1

SINAD

Signal-to-noise distortion

67.8

SNR

Signal-to-noise ratio

Signal-to-noise ratio (16-bit mode

oversampling with ratio =256)(4)

THD

Total harmonic distortion

-81

-68.5

1. ADC DC accuracy values are measured after internal calibration.

2. ADC accuracy vs. negative current injection: Injecting negative current on any of the standard (non-robust) analog input

pins must be avoided as it significantly reduces the accuracy of the conversion being performed on another analog input. It

is recommended to add a Schottky diode (pin to ground) to standard analog pins that may potentially inject negative

current.

Any positive current injection within the limits specified for IINJ(PIN) and ΣIINJ(PIN) in Section 6.3.12 does not affect the ADC

accuracy.

3. Better performance may be achieved in restricted VDDA, frequency and temperature ranges.

4. This number is obtained by the test board without additional noise, resulting in non-optimized value for oversampling mode.

ET = total unajusted error: maximum deviation

between the actual and ideal transfer curves.

EO = offset error: maximum deviation

between the first actual transition and

the first ideal one.

EG = gain error: deviation between the last

ideal transition and the last actual one.

ED = differential linearity error: maximum

deviation between actual steps and the ideal ones.

EL = integral linearity error: maximum deviation

between any actual transition and the end point

correlation line.

(1) Example of an actual transfer curve

(2) The ideal transfer curve

(3) End point correlation line

4095

4094

4093

4093 4094 4095 4096

VDDA

VSSA

1 LSB IDEAL

(1)

(3)

(2)

MS19880V2

STM32L010K8 Datasheet(PDF) 75 Page - STMicroelectronics

STM32L010K8 Datasheet(HTML) 75 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92

Datasheet Download

Link URL