AT89C5132-ROTUL datasheet(44/181 Pages) ATMEL

44 / 181 page

4173D–USB–02/06

AT89C5132

11. Power Management

2 power reduction modes are implemented in the AT89C5132: the Idle mode and the Power-

down mode. These modes are detailed in the following sections. In addition to these power

reduction modes, the clocks of the core and peripherals can be dynamically divided by 2 using

the X2 mode detailed in Section “X2 Feature”, page 12.

11.1

Reset

In order to start-up (cold reset) or to restart (warm reset) properly the microcontroller, an high

level has to be applied on the RST pin. A bad level leads to a wrong initialization of the internal

registers like SFRs, Program Counter… and to unpredictable behavior of the microcontroller. A

proper device reset initializes the AT89C5132 and vectors the CPU to address 0000h. RST input

has a pull-down resistor allowing power-on reset by simply connecting an external capacitor to

DD as shown in Figure 11-1. A warm reset can be applied either directly on the RST pin or indi-

rectly by an internal reset source such as the watchdog timer. Resistor value and input

characteristics are discussed in the Section “DC Characteristics” of the AT89C5132 datasheet.

The status of the Port pins during reset is detailed in Table 16.

Figure 11-1.

Reset Circuitry and Power-On Reset

Table 16. Pin Conditions in Special Operating Modes

Note:

1. Refer to Section “Audio Output Interface”, page 75.

11.1.1

Cold Reset

2 conditions are required before enabling a CPU start-up:

•V

DD must reach the specified VDD range

•

The level on X1 input pin must be outside the specification (V

IH, VIL)

If one of these 2 conditions are not met, the microcontroller does not start correctly and can exe-

cute an instruction fetch from anywhere in the program space. An active level applied on the

RST pin must be maintained till both of the above conditions are met. A reset is active when the

level V

IH1 is reached and when the pulse width covers the period of time where VDD and the

oscillator are not stabilized. 2 parameters have to be taken into account to determine the reset

pulse width:

•V

DD rise time,

•

Oscillator startup time.

Mode

Port 0

Port 1

Port 2

Port 3

Port 4

Port 5

MMC

Audio

Reset

Floating

High

Floating

Idle

Data

Power-down

Data

RST

VSS

To CPU Core

and Peripherals

RST

VDD

Power-on Reset

RST input circuitry

VDD

From Internal

Reset Source

AT89C5132-ROTUL Datasheet(PDF) 44 Page - ATMEL Corporation

AT89C5132-ROTUL Datasheet(HTML) 44 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL