W39V040FA

512K

× 8 CMOS FLASH MEMORY

WITH FWH INTERFACE

Publication Release Date: December 19, 2002

- 1 -

Revision A2

1. GENERAL DESCRIPTION

The W39V040FA is a 4-megabit, 3.3-volt only CMOS flash memory organized as 512K

× 8 bits. For

flexible erase capability, the 4Mbits of data are divided into 8 uniform sectors of 64 Kbytes, which are

composed of 16 smaller even pages with 4 Kbytes. The device can be programmed and erased in-

system with a standard 3.3V power supply. A 12-volt VPP is not required. The unique cell architecture

of the W39V040FA results in fast program/erase operations with extremely low current consumption.

This device can operate at two modes, Programmer bus interface mode and FWH bus interface

mode. As in the Programmer interface mode, it acts like the traditional flash but with a multiplexed

address inputs. But in the FWH interface mode, this device complies with the Intel FWH specification.

The device can also be programmed and erased using standard EPROM programmers.

2. FEATURES

•

Single 3.3-volt operations:

− 3.3-volt read

− 3.3-volt erase

− 3.3-volt program

•

Fast Program operation:

− Byte-by-Byte programming: 35 µS (typ.)

•

Fast erase operation:

− Chip erase 100 mS (max.)

− Sector erase 25 mS (max.)

− Page erase 25 mS (max.)

•

Fast Read access time: Tkq 11 nS

•

Endurance: 10K cycles (typ.)

•

Twenty-year data retention

•

8 Even sectors with 64K bytes each, which is

composed of 16 flexible pages with 4K bytes

•

Any individual sector or page can be erased

•

Hardware protection:

− Optional 16K byte or 64K byte Top Boot

Block with lockout protection

− #TBL & #WP support the whole chip

hardware protection

•

Flexible 4K-page size can be used as

Parameter Blocks

•

Low power consumption

− Active current: 12.5 mA (typ. for FWH mode)

•

Automatic program and erase timing with

•

End of program or erase detection

− Toggle bit

− Data polling

•

Latched address and data

•

TTL compatible I/O

•

Available packages: 32L PLCC, 32L STSOP,

40L TSOP (10 x 20 mm)