| Electronic Components Datasheet Search |
|
STM32U575VG Datasheet(PDF) 29 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STM32U575VG Datasheet(HTML) 29 Page - STMicroelectronics |
|
29 / 329 page ![]() DS13737 Rev 6 29/329 STM32U575xx Functional overview 88 3.6.2 Default TrustZone security state The default system security state is detailed below: • CPU: – Cortex-M33 is in secure state after reset. The boot address must be in secure address. • Memory map: – SAU is fully secure after reset. Consequently, all memory map is fully secure. Up to eight SAU configurable regions are available for security attribution. • Flash memory: – Flash memory security area is defined by watermark user options. – Flash memory block based area is non-secure after reset. • SRAMs: – All SRAMs are secure after reset. MPCBB (memory protection block based controller) is secure. • External memories: – FSMC, OCTOSPI banks are secure after reset. MPCWMx (memory protection watermark based controller) is secure. • Peripherals – Securable peripherals are non-secure after reset. – TrustZone-aware peripherals are non-secure after reset. Their secure configuration registers are secure. • All GPIOs are secure after reset. • Interrupts: – NVIC: All interrupts are secure after reset. NVIC is banked for secure and non- secure state. • TZIC: All illegal access interrupts are disabled after reset. 3.7 Boot modes At startup, a BOOT0 pin, nBOOT0, NSBOOTADDx[24:0] (x = 0, 1) and SECBOOTADD0[24:0] option bytes are used to select the boot memory address that includes: • Boot from any address in user Flash memory. • Boot from system memory bootloader. • Boot from any address in embedded SRAM. • Boot from RSS (root security services). The BOOT0 value comes from the PH3-BOOT0 pin or from an option bit depending on the value of a user option bit to free the GPIO pad if needed. The bootloader is located in the system memory, programmed by ST during production. The bootloader is used to reprogram the Flash memory by using USART, I2C, SPI, FDCAN or USB FS in device mode through the DFU (device firmware upgrade). The bootloader is available on all devices. Refer to the application note STM32 microcontroller system memory boot mode (AN2606) for more details. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |