PCDC1008-R215EMO datasheet(26/51 Pages) IRF

26 / 51 page

IR3447

www.irf.com

July 17, 2013

TYPICAL OPERATING WAVEFORM

DESIGN EXAMPLE

The following example is a typical application for

IR3447. The application circuit is shown in Figure 28.

Vin = PVin = 12V

Fs = 600kHz

Vo = 1.2V

Io = 25A

Ripple Voltage = ± 1% * Vo

∆Vo = ± 4% * Vo (for 30% load transient)

Enabling the IR3447

As explained earlier, the precise threshold of the

Enable lends itself well to implementation of a UVLO

for the Bus Voltage as shown in Figure 22.

Figure 22: Using Enable pin for UVLO implementation

For a typical Enable threshold of VEN = 1.2 V

(min)







(10)





(min)

(11)

For PVin (min)=9.2V, R1=49.9K and R2=7.5K ohm is a

good choice.

Programming the frequency

For Fs = 600 kHz, select Rt = 39.2 KΩ, using Table 1.

Output Voltage Programming

Output voltage is programmed by reference voltage

and external voltage divider. The FB pin is the

inverting input of the error amplifier, which is internally

referenced to VREF. The divider ratio is set to equal

VREF at the FB pin when the output is at its desired

value. When an external resistor divider is connected

to the output as shown in Figure 23, the output

voltage is defined by using the following equation:



















ref

(12)



















ref

(13)

For the calculated values of R5 and R6, see feedback

compensation section.

Figure 23: Typical application of the IR3447 for

programming the output voltage

Bootstrap Capacitor Selection

To drive the Control FET, it is necessary to supply a

gate voltage at least 4V greater than the voltage at the

SW pin, which is connected to the source of the

Control FET. This is achieved by using a bootstrap

configuration, which comprises the internal bootstrap

diode and an external bootstrap capacitor (C1). The

operation of the circuit is as follows: When the sync

FET is turned on, the capacitor node connected to SW

is pulled down to ground. The capacitor charges

towards Vcc through the internal bootstrap diode

(Figure 24), which has a forward voltage drop VD. The

voltage Vc across the bootstrap capacitor C1 is

approximately given as:





(14)

PCDC1008-R215EMO Datasheet(PDF) 26 Page - International Rectifier

PCDC1008-R215EMO Datasheet(HTML) 26 Page - International Rectifier

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51

Datasheet Download

Link URL