JS28F512P30TFA datasheet(28/86 Pages) MICRON

28 / 86 page

P30-65nm

Datasheet

Sept 2012

Order Number: 208042-0

program operation that is running during an erase suspend can be suspended to

perform a read operation (see Figure 31, “Program Suspend/Resume Flowchart” on

page 73).

When a programming operation is executing, issuing the Program Suspend command

requests the WSM to suspend the programming algorithm at predetermined points. The

device continues to output Status Register data after the Program Suspend command is

issued. Programming is suspended when Status Register bits SR[7,2] are set. Suspend

latency is specified in Section 15.5, “Program and Erase Characteristics” on page 59.

To read data from the device, the Read Array command must be issued. Read Array,

Read Status Register, Read Device Identifier, Read CFI, and Program Resume are valid

commands during a program suspend.

During a program suspend, deasserting CE# places the device in standby, reducing

active current. VPP must remain at its programming level, and WP# must remain

unchanged while in program suspend. If RST# is asserted, the device is reset.

8.5

Program Resume

The Resume command instructs the device to continue programming, and

automatically clears Status Register bits SR[7,2]. This command can be written to any

address. If error bits are set, the Status Register should be cleared before issuing the

next instruction. RST# must remain deasserted (see Figure 32, “Buffer Program

Flowchart” on page 74).

8.6

Program Protection

When VPP = VIL, absolute hardware write protection is provided for all device blocks. If

VPP is at or below VPPLK, programming operations halt and SR.3 is set indicating a VPP-

level error. Block Lock Registers are not affected by the voltage level on VPP; they may

still be programmed and read, even if VPP is less than VPPLK.

Figure 8: Example VPP Supply Connections

• Factory Programming with

PP = VPPH

• Complete write/Erase Protection when

PP ≤ VPPLK

VCC

VPP

VCC

VPP

• Low Voltage and Factory Programming

• Low-voltage Programming only

• Logic Control of Device Protection

VCC

VPP

• Low Voltage Programming Only

• Full Device Protection Unavailable

VCC

VPP

≤ 10K Ω

PROT #

PP=VPPH

JS28F512P30TFA Datasheet(PDF) 28 Page - Micron Technology

JS28F512P30TFA Datasheet(HTML) 28 Page - Micron Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86

Datasheet Download

Link URL