ATtiny88 datasheet(29/266 Pages) ATMEL

29 / 266 page

8008C–AVR–03/09

ATtiny48/88

When this clock source is selected, start-up times are determined by the SUT Fuses as shown in

Table 6-6.

Note:

1. If the RSTDISBL fuse is programmed, this start-up time will be increased to 14CK + 4 ms to

ensure programming mode can be entered.

6.5

External Clock

To drive the device from an external clock source, CLKI should be driven as shown in Figure 6-2

on page 29. To run the device on an external clock, the CKSEL Fuses must be programmed to

“00” (see Table 6-7).

Figure 6-2.

External Clock Drive Configuration

When this clock source is selected, start-up times are determined by the SUT Fuses as shown in

Table 6-8.

Table 6-6.

Start-up Times for the 128 kHz Internal Oscillator

SUT1..0

Power Conditions

Start-up Time

from Power-down

Additional Delay

from Reset

BOD enabled

6 CK

14CK(1)

Fast rising power

6 CK

14CK + 4 ms

Slowly rising power

6 CK

14CK + 64 ms

Reserved

Table 6-7.

Selecting External Clock

CKSEL1..0

Frequency

– 12 MHz

Table 6-8.

Start-up Times for the External Clock Selection

SUT1..0

Power Conditions

Start-up Time

from Power-down

Additional Delay

from Reset (V

CC = 5.0V)

BOD enabled

6 CK

14CK

EXTERNAL

CLOCK

SIGNAL

CLKI

GND

ATtiny88 Datasheet(PDF) 29 Page - ATMEL Corporation

ATtiny88 Datasheet(HTML) 29 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL