ST20-GP6 datasheet(74/123 Pages) STMICROELECTRONICS

74 / 123 page

ST20-GP6

74/123

The

SysRatio register, see Table 11.8 on page 69, gives the speed at which the system PLL is

running. It contains the relevant PLL multiply ratio when using the PLL, or contains the value ‘1’

when in

TimesOneMode for the PLL.

13.3.2 Clocking sources

The real time clock and low power timer and alarm must be clocked at all times by one of the following

clocking sources:

•

External clock input (

LowPowerClockIn) — this clock must not be more than one eighth of

the system clock rate. In this case the

LowPowerClockOsc pin should not be connected

on the board.

•

Watch crystal, as in Figure 13.1.

Figure 13.1 Watch crystal clocking source

SpeedSelect1

SpeedSelect0

Processor clock

speed (MHz)

Processor

cycle time (ns)

approximate

Phase lock loop

factor (PLLx)

RESERVED

16.368

61.1

TimesOneModea

a. In TimesOneMode the PLL is disabled to reduce power consumption.

32.736

30.5

49.104

20.4

Table 13.1 Processor speed selection

internal low power clock

watch crystal

LowPowerClockOsc

LowPowerClockIn

(32768 Hz)

GND

22 pF

10 pF

A - this node should have very low capacitance < 10 pF.

B - this node must have zero dc load.

330 K

Ω

ST20-GP6 Datasheet(PDF) 74 Page - STMicroelectronics

ST20-GP6 Datasheet(HTML) 74 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL